Cub Cadet 7252 manual Slope Operation, Children, Operating the PTO, Do not

Page 5

Maintain the weight balance of the tractor. Install front end weights to counterbalance heavy implements attached to the three point hitch. Do not operate the tractor with a light front end.

Any towed vehicle with a total weight exceeding that of the tractor should be equipped its own braking system that is operational from the tractor seat.

Do not leave equipment in the raised position.

Watch for traffic when operating near or crossing roadways. If local laws permit road travel, use the flashing hazard lights and SMV signs when traveling on public roadways.

Make certain all tractor lights are illuminated when operating at night.

Always watch where you are going, especially at blind corners, trees, or other objects that can obscure your vision.

Check overhead clearance carefully before driving under power lines, wires, bridges or low hanging tree branches, before entering or leaving buildings, or in any other situation where the operator and/or roll bar may be struck, which could result in serious injury.

To avoid upsets, drive the tractor with care and at a safe speed. Use extra caution when operating over rough ground, when crossing ditches or slopes, and when turning corners.

If the tractor becomes stuck, use reverse to free the tractor to prevent tractor upset.

2. SLOPE OPERATION

Slopes are a major factor related to loss of control and tip-over accidents which can result in severe injury or death. All slopes require extra caution. If you cannot back up the slope or if you feel uneasy on it, do not operate this unit on that area or serious injury could result.

DO:

Operate up and down slopes, not across.

Remove obstacles such as rocks, limbs, etc.

Watch for holes, ruts or bumps. Uneven terrain could overturn the machine. Tall grass can hide such obstacles.

Place the transmission in the low range. when climbing or descending slopes. Always keep machine in gear when going down slopes to take advantage of engine braking action.

Follow the manufacturers recommendations for counterweights to improve stability.

Keep all movement on the slopes slow and gradual. Do not make sudden changes in speed or direction. Rapid engagement or braking could cause the front of the machine to lift and rapidly flip over backwards which could cause serious injury.

Avoid starting or stopping on a slope. If tires lose traction, disengage the PTO and proceed slowly straight down the slope.

DO NOT:

Do not turn on slopes unless necessary; then, turn slowly and gradually downhill, if possible.

Do not mow near drop-offs, ditches or embankments. The mower could suddenly turn over if a wheel goes over the edge of a cliff or ditch, or if an edge caves in.

3. CHILDREN

Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to the machine. Never assume children will remain where you last saw them.

Keep children out of the operating area and in watchful care of an adult other than the operator.

Be alert and turn machine off if children enter the area.

Before and when backing, look behind and down for small children.

Never carry children. They may fall off and be seriously injured or interfere with safe machine operation.

Never allow children under 14 years old to operate the machine. Children 14 years and over should only operate machine under close parental supervision and proper instruction.

Use extra care when approaching blind corners, shrubs, trees or other objects that may obscure your vision of a child or other hazard.

Remove key when machine is unattended to prevent unauthorized operation.

4. OPERATING THE PTO

When operating PTO driven equipment, disengage the PTO, stop the engine, and wait until the PTO stops before dismounting the tractor and disconnecting the equipment.

Do not wear loose fitting clothing when operating the PTO or when near rotating equipment.

5

Image 5
Contents Operator’s Manual Important Read Safety Rules and Instructions CarefullyTo the Owner Table of ContentsCalling Service Information Rops Information Plate Recording Model and Serial Number InformationTractor Model Plate General Operation Important Safe Operation PracticesChildren Slope OperationOperating the PTO Do notService Safety Frame RopsStarting AID Safety LabelsFAN Warning Label Located on Each Side of Radiator Keep HandsRoll Over Warning Label Located on RIGHT/REAR Fender Battery Warning Label Located Under HoodPTO Warning Label Located on Rear PTO Shield Floorboard and Dash Panel Mounted Controls Controls and FeaturesIgnition Switch PTO SwitchSeat Adjustment Lever Steering WheelHeadlight Switch Hazard Light SwitchDifferential Lock Pedal Parking Brake LeverEngine Coolant Temperature Light Battery Indicator LightParking Brake Indicator Light PTO Indicator LightPTO Reverse Override Switch Fender Mounted Conrtols and FeaturesFuel Fill Cap PTO Selection LeverCup Holder Transmission Hi/Lo Range Shift LeverHand Holds Amber Hazard LightsOperation Safety Interlock SystemRollover Protective Structure Rops Fueling the TractorThrottle Handle Slow Fast PTO Switch ‘OFF’ Position NEW Tractor BREAK-IN ProceduresStarting the Engine Cold Weather StartingStopping the Engine Using Jumper Cables to Start the EngineDriving the Tractor Driving on SlopesStopping the Tractor Using the FORWARD/REVERSE PedalUsing the HI/LO Range Shift Lever Hydraulic Lift Lever Using the Differential Lock PedalUsing the Hydraulic Lift Lever Engaging the PTO Using the PTO Selection LeverUsing the Hitch Plate Using the PTO Reverse Override SwitchUsing the Three Point Hitch LightingFront Weights Tractor WeightingWeighting the Rear of the Tractor Rear Weight BoxAdjusting the Seat AdjustmentsAdjusting the Seat Belt Three Point Hitch AdjustmentsAdjustment Tube Adjusting Front Wheel TOE-INJAM NUT HEX Shaft HEX JAM NUTFeedback Links Rodhydraulic Lift Valve Adjusting the BrakesAdjusting Hydraulic Lift Feedback ROD Lubrication Table Tractor MaintenanceGeneral Information API11 5 Service Intervals Operation to Lubrication and Maintenance ChartGeneral Battery Information Accessing the Engine CompartmentBattery Maintenance Battery RemovalBattery Storage Battery Holddown ROD Wing NUT Holddown Strap Cable ClampTail Light Bulb Replacement Head Light Bulb ReplacementHazard Bulb Replacement Notch Lenses Bulb Socket Screw Inner Notch Housing OuterAccessing the Fuse Center Instrument Panel Bulb ReplacementServicing Electrical System Instrument Panel FusesChecking TRANSMISSION/HYDRAULIC System OIL Level Main FuseHazard Light Flasher Relay Transmission Drain Plug Changing TRANSMISSION/HYDRAULIC System OILHydrostatic Hydraulic System OIL Filter Initial Break-In Period Filter Change Tire Maintenance Maintenance of the Rollover Protective Structure RopsTire Inflation Chart Lubrication of Drive ShaftRemoving the Tractor from Storage Front of EngineTractor Storage Engine Information and Maintenance Limited Liability Cleaning the Engine Engine MaintenanceCleaning the Radiator Screen and Radiator Before servicingChanging the Engine OIL and Filter Adding Engine OILHEX Drain Cock Engine Valve Full Mark OIL Filter Coolant ADD Mark ReservoirRemote Radiator CAP Filler Neck Overflow Hose Checking Engine Coolant LevelInspection of Cooling System Hoses Changing the AIR CleanerChanging the Engine Coolant Overflow Reservoir Coolant Drain PlugServicing the Paper Element Servicing the Foam PrecleanerServicing the Spark Plugs Changing the Fuel FilterSpecifications General Dimensions Power Take-OffHydraulic Lift System BrakesModel Number Optional Equipment and AccessoriesDescription CLEVELAND, Ohio CUB Cadet LLC Post Office BOX

7252 specifications

The Cub Cadet 7252 is a noteworthy addition to the lineup of robust and reliable lawn tractors designed for residential homeowners and landscaping professionals alike. This model combines power, versatility, and advanced technology to deliver an exceptional mowing experience.

One of the standout features of the Cub Cadet 7252 is its powerful engine. It is equipped with a reliable, air-cooled Kohler engine, providing ample horsepower to tackle even the most demanding mowing tasks. This engine delivers smooth and consistent performance, ensuring that users can cut through thick grass and uneven terrain with ease. The hydrostatic transmission further enhances functionality by offering a seamless driving experience without the need for manual gear shifting.

The cutting deck of the Cub Cadet 7252 is another highlight. With a wide 50-inch cutting deck, it allows for efficient mowing over large areas, reducing the time spent on lawn maintenance. The deck features a reinforced steel construction for durability and longevity, capable of withstanding the rigors of regular use. Additionally, users can achieve different cutting heights with ease, thanks to the 12 position height adjustment feature, ranging from 1 to 4 inches.

Technologically, the 7252 model integrates innovative features for enhanced comfort and ease of use. The ergonomic high-back seat provides maximum support during extended mowing sessions, while the comprehensive dashboard displays essential information, such as fuel level and engine status, allowing for better operation management.

Furthermore, this lawn tractor is designed with user convenience in mind. It features a tight turning radius, which makes maneuvering around obstacles such as trees and flower beds incredibly easy. The Cub Cadet 7252 also offers optional attachments like baggers and snow blowers, making it a versatile tool for various seasonal tasks beyond lawn care.

Overall, the Cub Cadet 7252 is engineered for performance, comfort, and versatility. Combining a powerful engine, wide cutting deck, and innovative technologies, it serves as an excellent solution for homeowners looking to maintain their lawns efficiently while enjoying the convenience of modern machinery.