Cub Cadet 5254 manual A. Steering Wheel, B. Throttle Handle, C. PTO Switch, D. Ignition Switch

Page 10
A. Steering Wheel

NOTE: References to LEFT and RIGHT indicate that side of the tractor when facing forward while seated in the drivers seat. Reference to FRONT indicates the grille end of the tractor; to REAR, the tow plate end.

A. Steering Wheel

The steering wheel is centered on the dash panel, and used to change the direction (left or right) of the tractor while driving.

NOTE: This tractor is equipped with hydraulic power steering. With this feature, the cap and spokes of the steering wheel may change position.

B. Throttle Handle

This symbol indicates the fast position.

This symbol indicates the slow position.

The throttle handle is located to the right of the steering wheel on the dash panel. When set in a given position, a uniform engine speed will be maintained. Rotate the handle rearward to increase the engine speed.

C. PTO Switch

PTO

Switch

Symbol

Figure 2

The PTO switch is a rocker type switch located to the right of the steering wheel on the dash panel. Push the top of the PTO switch downward to engage the PTO. Push the bottom of the switch downward to disengage.

D. Ignition Switch

NOTE: To prevent accidental starting and/or battery discharge, remove the key from the ignition switch when the tractor is not in use.

The ignition switch has three positions as follow:

B. Throttle HandleC. PTO SwitchOFF

STOP

D. Ignition SwitchE. Brake PedalF.Reverse PedalON

G. Forward PedalManual backgroundManual backgroundSTART

Figure 3

OFF - Engine and electrical system is turned off.

ON - The tractor electrical system is energized.

START- The starter motor will turn over the engine. Release the key immediately when the engine starts

E. Brake Pedal

Brake Pedal

Symbol

Figure 4

The brake pedal is located at the front of the right running board above the forward and reverse pedals. Depress to engage the tractor brakes and neutralize the hydrostatic transmission. Fully depress the brake pedal to activate the safety interlock switch when starting the tractor.

F.Reverse Pedal

Reverse

Pedal

Symbol

Figure 5

The reverse control pedal is located on the right running board below the brake pedal. Press the pedal down to move in reverse.

WARNING: Check behind the tractor to be sure the area is clear of people, pets or obstacles and use a slower speed to maintain control of the tractor when traveling in reverse.

G. Forward Pedal

Forward

Pedal

Symbol

Figure 6

The forward control pedal is located on the right running board below the brake pedal. Slowly press down on the pedal to start moving forward. The forward ground speed of the tractor is directly affected by the distance the pedal is depressed.

10

Image 10
Contents SERIES IMPORTANT READ SAFETY RULES AND INSTRUCTIONS CAREFULLYOperator’s Manual TRACTORCALLING SERVICE INFORMATION TABLE OF CONTENTSTO THE OWNER Tractor Model Plate RECORDING MODEL AND SERIAL NUMBER INFORMATIONROPS INFORMATION PLATE Engine InformationIMPORTANT SAFE OPERATION PRACTICES 1. GENERAL OPERATION2. SLOPE OPERATION DO NOT3. CHILDREN 5. SAFETY FRAME ROPS6. SERVICE 4. OPERATING THE PTOCheck brake operation frequently. Adjust and service as required FAN WARNING LABEL LOCATED ON EACH SIDE OF RADIATOR SAFETY LABELSBATTERY WARNING LABEL LOCATED UNDER HOOD INSTRUCTION LABEL ON RIGHT RUNNING BOARDSECTION 1 CONTROLS AND FEATURES A. Steering Wheel C. PTO SwitchD. Ignition Switch B. Throttle HandleH. Hand Holds N. Seat Adjustment LeverR. PTO Reverse Override Switch J. Transmission 4WD Shift LeverT. Differential Lock Pedal V. Hazard Light SwitchW. Headlight Switch U. Choke Control Knob4. Oil Pressure Indicator 6. Brake Engaged Indicator3. Battery Indicator Light 5. PTO Engaged IndicatorROLLOVER PROTECTIVE STRUCTURE ROPS SAFETY INTERLOCK SYSTEMSECTION 2 OPERATION FOLDING THE ROPSFUELING THE TRACTOR NEW TRACTOR BREAK-IN PROCEDURESSTARTING THE ENGINE STOPPING THE ENGINE COLD WEATHER STARTINGDRIVING THE TRACTOR USING THE HI/LO RANGE SHIFT LEVER USING THE FORWARD AND REVERSE PEDALSSTOPPING THE TRACTOR DRIVING ON SLOPES USING THE DIFFERENTIAL LOCK PEDALUSING THE 4WD SHIFT LEVER Disengage 4WD Engage 4WDENGAGING THE PTO USING THE HYDRAULIC LIFT LEVERUSING THE PTO REVERSE OVERRIDE SWITCH LIGHTING HeadlightsHazard Lights USING THE TOP LINK RETAINER HOOKUSING THE THREE POINT HITCH REMOVING THE REAR PTO COVERFront Weights USING THE HITCH PLATETRACTOR WEIGHTING Weighting the Rear of the TractorADJUSTING THE SEAT BELT SECTION 3 ADJUSTMENTSADJUSTING THE SEAT THREE POINT HITCH ADJUSTMENTSADJUSTING FRONT WHEEL TOE-IN NOTE The right ball joint and jam nut are left hand threadedADJUSTING THE BRAKES LUBRICATION TABLE SECTION 4 TRACTOR MAINTENANCEGeneral Information LUBRICATION AND MAINTENANCE CHART ILLUSTRATION Operation to LUBRICATION AND MAINTENANCE CHARTService Intervals be PerformedACCESSING THE ENGINE COMPARTMENT GENERAL BATTERY INFORMATIONBATTERY MAINTENANCE BATTERY REMOVALCHARGING THE BATTERY BATTERY STORAGESERVICING ELECTRICAL SYSTEM HAZARD BULB REPLACEMENTMain Fuse Right Side Accessing the Lower Dash Panel AreaElectrical Circuit Relays Left SideCHECKING TRANSMISSION/HYDRAULIC SYSTEM OIL LEVEL 25 Hour Break-In Period Filter ChangeChanging Hydro Transmission Oil Filter CHANGING THE HYDRO TRANSMISSION AND HYDRAULIC SYSTEM OIL FILTERSChanging Hydraulic System Filter CHANGING THE HYDRO TRANSMISSION AND HYDRAULIC SYSTEM OILCheck Final Reduction Gear Case Oil CHECKING OIL LEVEL IN FRONT AXLE AND FINAL REDUCTION GEAR CASESCheck Front Axle Oil CHANGING FRONT AXLE AND FINAL REDUCTION GEAR CASE OILWHEEL LUG NUT TORQUE LUBRICATION OF DRIVE SHAFTLUBRICATION OF FWD DRIVE SHAFT FRONT AXLETIRE MAINTENANCE MAINTENANCE OF THE ROLLOVER PROTECTIVE STRUCTURE ROPSTRACTOR STORAGE Using a fuel stabilizerFRONT OF ENGINE 2. If storing the tractor for 30 days or moreKAWASAKI LIMITED WARRANTY CALIFORNIA AND FEDERAL SECTION 5 ENGINE INFORMATION AND MAINTENANCEEMISSIONS CONTROL SYSTEMS SMALL OFF-ROAD ENGINES 3. LIMITED LIABILITY CLEANING THE RADIATOR SCREEN AND RADIATOR ENGINE MAINTENANCECLEANING THE ENGINE CHECKING ENGINE OIL LEVELADDING ENGINE OIL CHANGING THE ENGINE OIL AND FILTERCHECKING ENGINE COOLANT LEVEL CHANGING THE ENGINE COOLANT CHANGING THE AIR CLEANERINSPECTION OF COOLING SYSTEM HOSES KNOB FOAM PRECLEANER ELEMENTSERVICING THE PAPER ELEMENT SERVICING THE FOAM PRECLEANERIMPORTANT Do not apply oil to the foam precleaner element SERVICING THE SPARK PLUGSCooling System SECTION 6 SPECIFICATIONSEngine Electrical SystemGeneral Dimensions SPECIFICATIONSPower Take-Off Hydraulic Lift SystemSECTION 7 OPTIONAL EQUIPMENT AND ACCESSORIES HOW TO OBTAIN SERVICE CUB CADET LLC POST OFFICE BOX CLEVELAND, OHIOLIMITED WARRANTY FOR CUB CADET COMPACT TRACTORS AND CUB CADET ATTACHMENTS