Cub Cadet 5254 manual Front Of Engine, Tractor Storage, If storing the tractor for 30 days or more

Page 37
TRACTOR STORAGE

TRACTOR STORAGE

If your tractor is not going to be operated for an extended period of time (thirty days to approxi- mately six months), the tractor should be prepared for storage. Store the tractor in a dry and protected location. If stored outside, cover the tractor (includ- ing the tires) to protect it from the elements. The procedures outlined below should be performed whenever the tractor is placed in storage.

1.Change the engine oil and filter following the instructions provided in CHANGING THE ENGINE OIL AND FILTER in SECTION 5.

WARNING: Never store the tractor with fuel in the tank indoors or in poorly ventilated enclosures, where fuel fumes may reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer, etc.

WARNING: Fuel left in the fuel tank deteriorates and will cause serious starting problems.

2.If storing the tractor for 30 days or more:

To prevent gum deposits from forming inside the engine’s carburetor and causing possible malfunction of the engine, the fuel system must be either completely emptied, or the gasoline must be treated with a stabilizer to prevent deterioration.

Using a fuel stabilizer:

Read the product manufacturer’s instructions and recommendations.

Add to clean, fresh gasoline the correct amount of stabilizer for the capacity (approximately 6 gallons) of the fuel system.

Fill the fuel tank with treated fuel and run the engine for 2-3 minutes to get stabilized fuel into the carburetor.

Emptying the fuel system:

Prior to putting the tractor in storage, monitor fuel consumption with the goal of running the fuel tank empty.

If a large volume of fuel is left-over, the fuel line can be disconnected at the fuel filter and the leftover fuel drained into an approved container.

Run the engine until it begins to stall. Use the choke to keep the engine running until all fuel in the carburetor has been exhausted.

Place a small container or rag beneath the carburetor bowl drain and loosen the drain screw to completely drain the fuel from the carburetor. See Figure 50.

FRONT OF ENGINE

CARBURETOR

BOWL

DRAIN

SCREW

CARBURETOR

BOWL DRAIN

LEFT VALVE

COVER

Figure 50

3.Clean the engine and the entire tractor thoroughly.

4.Drain and flush the cooling system. Refill with a minimum 50/50 antifreeze and water coolant solution. Use a higher percentage of antifreeze if the tractor will be subjected to temperatures below minus 30° F.

5.Fully charge the battery, then disconnect the negative cable at the battery to prevent possi- ble discharge. Recharge the battery periodically when in storage.

NOTE: Remove the battery if exposed to prolonged periods of sub-freezing temperatures. Store in a cool, dry location where temperatures are above freezing.

6.Lubricate all lubrication points.

7.Jack up and block the tractor to remove the weight from the tires if stored for a long period. If not blocked up, reinflate the tires regularly.

NOTE: We do not recommend the use of a pressure washer or garden hose to clean your tractor. They may cause damage to electrical components; spindles; pulleys; bearings; or the engine. The use of water will result in shortened life and reduce serviceability.

REMOVING THE TRACTOR FROM STORAGE

Check the engine oil and coolant levels.

Fully charge the battery and inflate the tires to the recommended pressure.

Start the engine and allow to idle for a few minutes to ensure engine is operating properly.

Drive the tractor without a load to make certain all the tractor systems are functioning properly.

37

Image 37
Contents Operator’s Manual IMPORTANT READ SAFETY RULES AND INSTRUCTIONS CAREFULLYSERIES TRACTORCALLING SERVICE INFORMATION TABLE OF CONTENTSTO THE OWNER ROPS INFORMATION PLATE RECORDING MODEL AND SERIAL NUMBER INFORMATIONTractor Model Plate Engine Information1. GENERAL OPERATION IMPORTANT SAFE OPERATION PRACTICESDO NOT 2. SLOPE OPERATION6. SERVICE 5. SAFETY FRAME ROPS3. CHILDREN 4. OPERATING THE PTOCheck brake operation frequently. Adjust and service as required BATTERY WARNING LABEL LOCATED UNDER HOOD SAFETY LABELSFAN WARNING LABEL LOCATED ON EACH SIDE OF RADIATOR INSTRUCTION LABEL ON RIGHT RUNNING BOARDSECTION 1 CONTROLS AND FEATURES D. Ignition Switch C. PTO SwitchA. Steering Wheel B. Throttle HandleR. PTO Reverse Override Switch N. Seat Adjustment LeverH. Hand Holds J. Transmission 4WD Shift LeverW. Headlight Switch V. Hazard Light SwitchT. Differential Lock Pedal U. Choke Control Knob3. Battery Indicator Light 6. Brake Engaged Indicator4. Oil Pressure Indicator 5. PTO Engaged IndicatorSECTION 2 OPERATION SAFETY INTERLOCK SYSTEMROLLOVER PROTECTIVE STRUCTURE ROPS FOLDING THE ROPSFUELING THE TRACTOR NEW TRACTOR BREAK-IN PROCEDURESSTARTING THE ENGINE STOPPING THE ENGINE COLD WEATHER STARTINGDRIVING THE TRACTOR USING THE HI/LO RANGE SHIFT LEVER USING THE FORWARD AND REVERSE PEDALSSTOPPING THE TRACTOR USING THE 4WD SHIFT LEVER USING THE DIFFERENTIAL LOCK PEDALDRIVING ON SLOPES Disengage 4WD Engage 4WDUSING THE PTO REVERSE OVERRIDE SWITCH USING THE HYDRAULIC LIFT LEVERENGAGING THE PTO LIGHTING HeadlightsUSING THE THREE POINT HITCH USING THE TOP LINK RETAINER HOOKHazard Lights REMOVING THE REAR PTO COVERTRACTOR WEIGHTING USING THE HITCH PLATEFront Weights Weighting the Rear of the TractorADJUSTING THE SEAT SECTION 3 ADJUSTMENTSADJUSTING THE SEAT BELT THREE POINT HITCH ADJUSTMENTSNOTE The right ball joint and jam nut are left hand threaded ADJUSTING FRONT WHEEL TOE-INADJUSTING THE BRAKES LUBRICATION TABLE SECTION 4 TRACTOR MAINTENANCEGeneral Information LUBRICATION AND MAINTENANCE CHART ILLUSTRATION Service Intervals LUBRICATION AND MAINTENANCE CHARTOperation to be PerformedGENERAL BATTERY INFORMATION ACCESSING THE ENGINE COMPARTMENTCHARGING THE BATTERY BATTERY REMOVALBATTERY MAINTENANCE BATTERY STORAGESERVICING ELECTRICAL SYSTEM HAZARD BULB REPLACEMENTMain Fuse Electrical Circuit Relays Accessing the Lower Dash Panel AreaRight Side Left SideChanging Hydro Transmission Oil Filter 25 Hour Break-In Period Filter ChangeCHECKING TRANSMISSION/HYDRAULIC SYSTEM OIL LEVEL CHANGING THE HYDRO TRANSMISSION AND HYDRAULIC SYSTEM OIL FILTERSCHANGING THE HYDRO TRANSMISSION AND HYDRAULIC SYSTEM OIL Changing Hydraulic System FilterCheck Front Axle Oil CHECKING OIL LEVEL IN FRONT AXLE AND FINAL REDUCTION GEAR CASESCheck Final Reduction Gear Case Oil CHANGING FRONT AXLE AND FINAL REDUCTION GEAR CASE OILLUBRICATION OF FWD DRIVE SHAFT LUBRICATION OF DRIVE SHAFTWHEEL LUG NUT TORQUE FRONT AXLEMAINTENANCE OF THE ROLLOVER PROTECTIVE STRUCTURE ROPS TIRE MAINTENANCEFRONT OF ENGINE Using a fuel stabilizerTRACTOR STORAGE 2. If storing the tractor for 30 days or moreKAWASAKI LIMITED WARRANTY CALIFORNIA AND FEDERAL SECTION 5 ENGINE INFORMATION AND MAINTENANCEEMISSIONS CONTROL SYSTEMS SMALL OFF-ROAD ENGINES 3. LIMITED LIABILITY CLEANING THE ENGINE ENGINE MAINTENANCECLEANING THE RADIATOR SCREEN AND RADIATOR CHECKING ENGINE OIL LEVELCHANGING THE ENGINE OIL AND FILTER ADDING ENGINE OILCHECKING ENGINE COOLANT LEVEL INSPECTION OF COOLING SYSTEM HOSES CHANGING THE AIR CLEANERCHANGING THE ENGINE COOLANT KNOB FOAM PRECLEANER ELEMENTIMPORTANT Do not apply oil to the foam precleaner element SERVICING THE FOAM PRECLEANERSERVICING THE PAPER ELEMENT SERVICING THE SPARK PLUGSEngine SECTION 6 SPECIFICATIONSCooling System Electrical SystemPower Take-Off SPECIFICATIONSGeneral Dimensions Hydraulic Lift SystemSECTION 7 OPTIONAL EQUIPMENT AND ACCESSORIES LIMITED WARRANTY FOR CUB CADET COMPACT TRACTORS CUB CADET LLC POST OFFICE BOX CLEVELAND, OHIOHOW TO OBTAIN SERVICE AND CUB CADET ATTACHMENTS