Pioneer AVH-P4900D Adjusting the speaker output levels, Available accessories, 64 En

Section

04 Available accessories

Note

Selecting a cross-over frequency is to set a cross- over frequency of the subwoofer’s L.P.F. (low-pass filter) and that of the SMALL speaker H.P.F. (high- pass filter). The cross-over frequency setting has no effect if the subwoofer is set to OFF and other speakers are set to LARGE or OFF.

Adjusting the speaker output levels

You can readjust the speaker output levels using a test tone while listening to music.

1Touch NEXT on the DSP function menu.

2Touch SP LEVEL.

3Touch aor bto select the speaker to be adjusted.

Each time you touch aor bselects the speak- er in the following order:

FRONT-L (front speaker left)—CENTER (center speaker)—FRONT-R (front speaker right)— REAR-R (rear speaker right)—REAR-L (rear speaker left)—SUB WOOFER (subwoofer)

# You cannot select speakers whose size is set at OFF.

4Touch cor dto adjust the speaker out- put level.

Each time you touch cor dincreases or de- creases the speaker output level. +10 to –10 is displayed as the level is increased or de- creased.

Notes

!You can also display the speaker setting menu by pressing BOOST button.

!To adjust the speaker output levels in this mode is the same as making the speaker out- put levels at TEST TONE. Both provide the same results.

Adjusting the speaker output levels using a test tone

This function allows you to easily get the over- all balance right among the speakers.

1Touch NEXT on the DSP function menu.

2Touch TEST TONE.

3Touch START to start the test tone out- put.

The test tone is outputted. It rotates from speaker to speaker in the following sequence at intervals of about two seconds. The current settings for the speaker over which you hear the test tone are shown in the display. FRONT-L (front speaker left)—CENTER (center speaker)—FRONT-R (front speaker right)— REAR-R (rear speaker right)—REAR-L (rear speaker left)—SUB WOOFER (subwoofer) Check each speaker output level. If no adjust- ments are needed, perform step 5 to stop the test tone.

# The settings do not appear for speakers whose size is set OFF.

4Touch cor dto adjust the speaker out- put level.

Each time you touch cor dincreases or de- creases the speaker output level. +10 to –10 is displayed as the level is increased or de- creased.

# The test tone rotates to the next speaker after about two seconds from the last operation.

5Touch STOP to stop the test tone out- put.

Notes

!You can also display the speaker output level menu by pressing BOOST button.

64 En