H. Hand Holds
Hand holds are built into both the left and right hand fender covers. The handles can be used to assist in mounting and dismounting the tractor.
J. Transmission 4WD Shift Lever
The 4WD shift lever is located on the right fender. This lever is used to engage the transmission drive that powers the front transaxle. Push the lever forward to engage the 4WD, and pull the lever rearward to disengage.
K. Hydraulic Lift Lever
The hydraulic lift lever is located on the right fender. This lever is used to raise and lower the three point hitch lift arms.
•Move the lift lever fully rearward to raise the lift arms.
•Move the lift lever forward to lower the lift arms.
•Move the lift lever fully forward and inward to lock in the float position.
L. Cup Holder
The cup holder is located on the right fender.
M. Amber Hazard Lights
The hazard lights are located on each side of the ROPS. The lights illuminate in a flashing mode when the hazard light switch is turned on. Always use the hazard lights when it is necessary to warn others that the tractor is being operated in the area.
N. Seat Adjustment Lever
The seat adjustment lever is located at the right/ front of the seat. This lever is used to adjust the seat forward or backward.
O. Seat Belt
The seat belt, when properly adjusted and used in conjunction with the Rollover Protective Structure (ROPS), can greatly reduce the risk of serious injury or death to the operator if an accidental tractor overturn occurs.
WARNING: DO NOT use the seat belt if the ROPS structure has been removed from the tractor.
P. Fuel Fill Cap
The fuel fill cap is located on the left fender beside the operator’s seat.
Q. Transmission Hi/Lo Range Shift Lever
The Hi/Lo range shift lever is located on the left fender. The lever has two speed range settings and a neutral position. The lever must be shifted into either the high or low range prior to depressing the forward or reverse pedal to drive the tractor.
•Push the lever forward to shift into the high range.
•Pull the lever rearward to shift into the low range.
•Move the lever to the center position to shift into the neutral position.
WARNING: Never attempt to shift the Hi/Lo range lever when the tractor is in motion.
R. PTO Reverse Override Switch
The PTO reverse override switch is located on the left fender. Depress the front of the switch to engage the override which allows the PTO to operate while the tractor is traveling in the reverse direction. Once activated, this function remains activated until the ignition switch is turned to the OFF position for a duration of at least 20 seconds, regardless of the number of times the PTO is turned off using the PTO switch.
WARNING: Use EXTREME caution when operating PTO driven attach- ments while traveling in the reverse direction.
S. Parking Brake Lever
Parking
Brake
Symbol
Figure 7
The parking brake lever is located below the steering wheel in the dash panel. With the brake pedal fully depressed, push the parking brake lever downward and release the brake pedal to lock the parking brake.
11