Husky 70 Series, 1800 Series manual Replacing Bearing and Seal Assembly Item 26, New Style

GASBOY Series 70 & 1820

Replacing Bearing and Seal Assembly (Item 26, New Style)

To replace the bearing and shaft seal assembly (26), or service the gear train on back of register housing (18), remove housing from meter by taking out four screws. NOTE: The meter housing will be full of liquid so some means should be available to catch what drains from the case and lines. To remove gears (22-25), remove three retaining rings (20) and drive key (21). Withdraw the drive shaft and gear (14), spacer (15), and all parts of bearing and seal assembly (26). Remove the nylon washer from item 26 and note its location. Remove both oilite bearings and both O-rings from bore in register housing. Using new parts, which consist of a new nylon washer, 2 oilite bearings, and 2 O-rings, reassembly parts in reverse order. Be sure to lubricate both O-rings with an O-ring lubricant before assembling.

Reassemble gear train in following sequence: gear (25), key (21), cluster gear (24), retaining ring (20), control block (22), and retaining ring (20).

5-8 0144