Black & Decker BDG3100-B3 Assembly Instructions, Operation, Basic Elements of AN Engine

Page 33

J.Pump Inlet

K.Quick Connect Nozzles

L.On Board Detergent Tank (BDG3100-B3): Feeds cleaning agents into the pump to mix with the water. See How To Apply

Chemicals/Cleaning Solvents instructions in Operation section.

BASIC ELEMENTS OF AN ENGINE

Refer to the engine manual for location and operation of engine controls.

Choke Control: Opens and closes carburetor choke valve.

Starter Grip: Pulling starter grip operates recoil starter to crank engine.

Engine Switch: Enables and disables ignition system.

ASSEMBLY INSTRUCTIONS

(FIG. 1– 4)

1.Locate and remove all loose parts from the carton.

2.Cut four corners of the carton from top to bottom and lay the panels flat.

3.Place handle (G) onto frame (H), depress the snap buttons, and slide the handle assembly onto the frame until snap buttons snap into place.

2

G

H

NOTICE: Risk of personal injury. Avoid placing hands between handle and frame when assembling to prevent pinching.

4.Remove the colored quick-connect nozzles (K) from the plastic bag and insert them into correct grommet on the nozzle holder. Nozzles are color coded to match colored nozzles on label (Q).

2A K

Q

5.

Connect wand (E) to gun (D).

 

Tighten securely.

 

3

E

D

 

6.

Attach high pressure hose (C) to

 

gun (D). Tighten secure­ly­.

4

D

C

NOTE: The pump on this unit is maintenance free and requires no oil. If there is a problem with the pump, contact our Customer Service Group on www.BlackandDecker-la.comas soon as possible.

NOTICE: The engine is shipped without oil. Before starting engine, add the oil provided. Damage to the engine will occur if the engine is run without oil, this damage will not be covered under warranty.

OPERATION

PRESSURE WASHER

TERMINOLOGY

PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used for air pressure, hydraulic pressure, etc. Sometimes noted as “Bar”, another unit of measure.

GPM: Gallons per Minute. The unit of measure for the flow rate of water.

CU: Cleaning Units. GPM multiplied by psi equals CU.

Bypass Mode: Allows water to re-circulate within the pump when the gun trigger is not pulled. This feature allows the operator to release the

33-­ ENG

Image 33
Contents Part No Rev APR VEA EL Español EN LA ContraportadaInstalación Fácil Easy InstallationAbra Completamente Fully Open Page Instrucciones DE Seguridad Importantes Definiciones DE Normas DE Seguridad¿QUÉ Puede SUCEDER? Cómo Evitarlo Peligro Riesgo DE Explosión O IncendioEl motor CombustiblePintadas Presión a una distancia mínima deSimilar en la manguera de alta presión Un agujero o causa de pérdida de aguaIntentar realizarle mantenimiento o Lavadora a presiónManos o los brazos Que se produzcan lesiones en lasDe incendio o inhalación. Puede Lo cual podría generar peligroCausar lesiones graves o la muerte Transporta en posición verticalLimpiadores y Desgrasadores El uso de ácidos, químicosProducto Podría provocar Una Uso doméstico Recomendados El intento deFamiliarícese CON LA Lavadora a Presión Elementos Básicos DE UNA Lavadora a PresiónMotor Acciona la bomba de alta presión Elementos Básicos DEL Motor Instrucciones ParaConecte el tubo aplicador E a la Pistola D y ajústelo firmementeOperación Terminología DE LA Lavadora a PresiónCaracterísticas DE Operación DE LA Lavadora a Presión Estuco y ladrillo pintado Vinilo, revestimientoExterior pintado Aplicación de productos químicos BDG2600-B3 Cómo Emplear Productos Químicos Y Solventes Para LimpiezaLuego de usar productos químicos, coloque la manga de Aplicación de productos químicos BDG3100-B3No use agua caliente, sólo agua fría Arranque FIGSuelte el gatillo para detener el flujo de agua Apagado MantenimientoMotor Bomba ConexionesBomba FIG Cómo Limpiar EL Filtro DE Entrada DEL Agua FIGEspecificaciones AccesoriosModelo BDG2600-B3 BDG3100-B3Garantía Limitada Información DE ServicioGarantía DEL Motor Responsabilidad DEL Comprador Original Usuario InicialProblema Causa Corrección Guía DE Diagnóstico DE ProblemasEsta Garantía no Cubre PÉRDIDAS, Daños NI Gastos LAS Garantías IMPLÍCITAS, Incluidas LAS DE ComercialidadPara el Uso del Tubo Aplicador Para el Limpiador de BoquillasEl Uso del Tubo Aplicador 25-­ SP Important Safety Instructions Safety Guidelines DefinitionsWhat can Happen HOW to Prevent IT Never touch, grasp or attempt to cover Do not spray flammable liquidsGuns with this pressure washer, do When using replacement lances orNot use a lance and/or lance/gun Combination that is shorter in lengthDo not use pressure washer while Washer at all timesCarpet, paint or other­ surfaces Upon arrival at your destinationOr any kind of flamma­ble­ solvent Osene,­ or any other flammableWith this product could result­ Unplug any electri­cal­ly­ oper­at­ed­Basic Elements of a Pressure Washer FIG GET to Know the Pressure WasherOperation Assembly InstructionsBasic Elements of AN Engine Pressure Washer TerminologyPressure Adjustments Pressure Washer Operating FeaturesHOW to USE Spray Wand Thermal Relief ValveYellow Unpainted Or brick walkways Hard surfaces Nozzle Spray Uses Surfaces Color PatternDamaged due to chemicals will not be covered under warranty Starting FIGTo Apply chemicals BDG3100-B3 Do not use hot water, use cold water only Nozzle Cleaning FIG MaintenanceShutting Down Engine Pump ConnectionsDamage is not Covered by the Warranty Clean the Water Inlet Filter FIGStorage EngineService Information Accessories SpecificationsLimited Warranty Pressure WasherResponsibility of Original Purchaser Initial User Operational Possible Cause Solution Issue Trouble Shooting GuideSee How to Use Spray See Nozzle CleaningCorrect procedure Into cleaning solutionWill not draw Spray wand not Chemicals Low pressure Wand paragraphEnsamblado EN LOS E.E.U.U Made in USA