Zenoah BCZ2600SW, BCZ2600SU Recommended Mixing Ratio Gasoline 50OIL, HOW to MIX Fuel,  15 

Page 15

7. Fuel

WARNING

Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 3m (10ft) away from the fueling point before starting the engine.

The RedMax engines are lubricated by oil specially formulated for air-cooled 2-cycle gasoline engine use. If RedMax oil is not available, use an anti-oxidant added quality oil expressly labeled for air-cooled 2-cycle engine use. (JASO FC GRADE OIL or ISO EGC GRADE)

Do not use BIA or TCW (2-stroke water- cooling type) mixed oil.

RECOMMENDED MIXING RATIO GASOLINE 50:OIL 1

50:1 MIXING CHART

GASOLINE gal. 1 2 3 4 5

2-CYCLE OIL fl.oz 2.6 5.2 7.8 10.4 13

GASOLINE liter 1

2

3

4

5

2-CYCLE OIL ml 20 40 60 80 100

Exhaust emission are controlled by the fundamental engine parameters and components(eq., carburation, ignition timing and port timing) without addition of any major hardware or the introduction of an inert material during combustion.

These engines are certified to operate on unleaded gasoline.

Make sure to use gasoline with a minimum octane number of 89 RON (USA/Canada: 87AL)

If you use a gasoline of a lower octane value than prescribed, there is a danger that the engine temperature may rise and an engine problem such as piston seizing may consequently occur.

Unleaded gasoline is recommended to reduce the contamination of the air for the sake of your health and the environment.

Poor quality gasolines or oils may damage sealing rings, fuel lines or fuel tank of the engine.

HOW TO MIX FUEL

IMPORTANT

Pay attention to agitation.

1.Measure out the quantities of gasoline and oil to be mixed.

2.Put some of the gasoline into a clean, approved fuel container.

3.Pour in all of the oil and agitate well.

4.Pour In the rest of gasoline and agitate

15

Image 15
Contents BCZ2600SU BCZ2600SWContents Safety FirstParts location Specifications 4   5  Symbols on the machine 6  For safe operationWorking Condition Working Circumstance 7  Working PlanBefore Starting the Engine Starting the Engine 8   9  Using the Product 10  MaintenanceIf Someone Comes Handling Fuel 11  Transportation 12  Putting on Waist PAD SE5SE6 SE7 SE8 SE9 Mounting Engine SE5 14  Set upInstalling Cutting Head SE10 Balance Unit 15  HOW to MIX FuelFuel Recommended Mixing Ratio Gasoline 50OILFueling the Unit For Your Engine LIFE, Avoid 16  OP4 OperationOP1 Starting Engine 18  Adjusting the Line Length OP7 19   20  MaintenanceMaintenance Chart MA1 21   22  Procedures to be Performed After Every 100 Hours of USE MA8 23   24  Storage 25  Optional blade usage 26  OPT3BCZ2600SU OPT4 BCZ2600SU OPT5 OPT6 27  OPT7 OPT8Operation Controlling Blade Bounce 28  What causes kick outOPT9 Maintenance Blade Transporting the Unit 29  Troubleshooting guide Check Probable Causes Action 30   31  Parts list 32   33  Optional Blade & Accessories 34  Drive Unit BCZ2600SW S/N 300001 and up 35  Optional Blade 36   37  BCZ2600S S/N 50100000 and up BCZ2600SU S/N 50100000 and upLimited Warranty RedMax Garantie limitée Komatsu Zenoah America INC