Zenoah BCZ2600SU, BCZ2600SW manual Fueling the Unit, For Your Engine LIFE, Avoid,  16 

Page 16

7. Fuel

again for at least one minute. As some oils may be difficult to agitate depending on oil ingredients, sufficient agitation is necessary for the engine to last long. Be careful that, if the agitation is insufficient, there is an increased danger of early piston seizing due to abnormally lean mixture.

5.Put a clear indication on the outside of the container to avoid mixing up with gasoline or other containers.

6.Indicate the contents on outside of container for easy identification.

FUELING THE UNIT

1.Untwist and remove the fuel cap. Rest the cap on a dustless place.

2.Put fuel into the fuel tank to 80% of the full capacity.

3.Fasten the fuel cap securely and wipe up any fuel spillage around the unit.

WARNING

1.Select bare ground for fueling.

2.Move at least 10feet (3meters) away from the fueling point before starting the engine.

3.Stop the engine before refueling the unit. At that time, be sure to sufficiently agitate the mixed gasoline in the container.

FOR YOUR ENGINE LIFE, AVOID;

1.FUEL WITH NO OIL(RAW GASOLINE) – It will cause severe damage to the internal engine parts very quickly.

2.GASOHOL – It can cause deterioration of rubber and/or plastic parts and disruption of engine lubrication.

3.OIL FOR 4-CYCLE ENGINE USE – It can cause spark plug fouling, exhaust port blocking, or piston ring sticking.

4.Mixed fuels which have been left unused for a period of one month or more may clog the carburetor and result in the engine failing to operate properly.

5.In the case of storing the product for a

16

long period of time, clean the fuel tank after rendering it empty. Next, activate the engine and empty the carburetor of the composite fuel.

6.In the case of scrapping the used mixed oil container, scrap it only at an authorized repository site.

NOTE

As lot details of quality assurance, read the description in the section Limited Warranty carefully. Moreover, normal wear and change in product with no functional influence are not covered by the warranty. Also, be careful that, if the usage in the instruction manual is not observed as to the mixed gasoline, etc. described therein, it may not be covered by the warranty.

Image 16
Contents BCZ2600SW BCZ2600SUSafety First ContentsSpecifications Parts location 4  Symbols on the machine  5 For safe operation Working ConditionWorking Circumstance  6 Working Plan  7 Starting the Engine Before Starting the Engine 8  Using the Product  9 Maintenance If Someone ComesHandling Fuel  10 Transportation  11  12  SE5 SE6SE7 SE8 SE9 Mounting Engine SE5 Putting on Waist PADSet up Installing Cutting Head SE10Balance Unit  14 HOW to MIX Fuel FuelRecommended Mixing Ratio Gasoline 50OIL  15 For Your Engine LIFE, Avoid Fueling the Unit 16  Operation OP1Starting Engine OP4 18  OP7 Adjusting the Line Length 19  Maintenance Maintenance ChartMA1  20  21   22  MA8 Procedures to be Performed After Every 100 Hours of USE 23  Storage  24 Optional blade usage  25 OPT3 BCZ2600SU OPT4BCZ2600SU OPT5 OPT6  26 OPT7 OPT8 OperationControlling Blade Bounce  27 What causes kick out  28 Transporting the Unit OPT9 Maintenance Blade 29  Check Probable Causes Action Troubleshooting guide 30  Parts list  31  32  Optional Blade & Accessories  33 Drive Unit BCZ2600SW S/N 300001 and up  34 Optional Blade  35  36  BCZ2600S S/N 50100000 and up BCZ2600SU S/N 50100000 and up  37 Limited Warranty RedMax Garantie limitée Komatsu Zenoah America INC