Zenoah BCZ2600SU, BCZ2600SW manual  22 

Page 22

9. Maintenance

MA5

(1)

MA6

22

MUFFLER

WARNING

Inspect periodically, the muffler for loose fasteners, any damage or corrosion. If any sign of exhaust leakage is found, stop using the machine and have it repaired immediately.

Note that failing to do so may result in the engine catching on fire.

SPARK ARRESTER

The muffler is equipped with a spark arrester to prevent red hot carbon from flying out of the exhaust outlet. Periodically inspect and clean as necessary with a wire brush. In the State of California it is required by law (Section 4442 of the California Public Resources Code) to equip a spark arrester when a gas powered tool is used in any forest covered, brush covered, or grass covered unimproved land. (MA5)

(1) spark arrester

GEAR CASE (MA6)

The reduction gears are lubricated by multipurpose, lithium-based grease in the gear case. Supply new grease every 25 hours of use or more often depending on the job condition.

Remove the cutter holders before installing new grease to arrange for old grease to exit.

INTAKE AIR COOLING VENT

WARNING

Never touch the cylinder, muffler, or spark plugs with your bare hands immediately after stopping the engine. The engine can become very hot when in operation, and doing so could result in severe burns.

When checking the machine to make sure that it is okay before using it, check the area around the muffler and remove any wood chips or leaves which have attached

Image 22
Contents BCZ2600SW BCZ2600SUSafety First ContentsSpecifications Parts location 4  Symbols on the machine  5 Working Circumstance For safe operationWorking Condition  6 Working Plan  7 Starting the Engine Before Starting the Engine 8  Using the Product  9 Handling Fuel MaintenanceIf Someone Comes  10 Transportation  11  12  SE7 SE8 SE9 Mounting Engine SE5 SE5SE6 Putting on Waist PADBalance Unit Set upInstalling Cutting Head SE10  14 Recommended Mixing Ratio Gasoline 50OIL HOW to MIX FuelFuel  15 For Your Engine LIFE, Avoid Fueling the Unit 16  Starting Engine OperationOP1 OP4 18  OP7 Adjusting the Line Length 19  MA1 MaintenanceMaintenance Chart  20  21   22  MA8 Procedures to be Performed After Every 100 Hours of USE 23  Storage  24 Optional blade usage  25 BCZ2600SU OPT5 OPT6 OPT3BCZ2600SU OPT4  26 Controlling Blade Bounce OPT7 OPT8Operation  27 What causes kick out  28 Transporting the Unit OPT9 Maintenance Blade 29  Check Probable Causes Action Troubleshooting guide 30  Parts list  31  32  Optional Blade & Accessories  33 Drive Unit BCZ2600SW S/N 300001 and up  34 Optional Blade  35  36  BCZ2600S S/N 50100000 and up BCZ2600SU S/N 50100000 and up  37 Limited Warranty RedMax Garantie limitée Komatsu Zenoah America INC