Troy-Bilt 675B manual Attachreverseclutch Controlcable, Attachforwardclutch Controlcable

Figure2-4:Attach handlebars.

5.Move the handlebars up or down to align the threaded hole in the cross-brace with one of the four slots in the curved height adjustment bracket. Placethe keyed washer (E, Figure 2-3) on the flange head height adjustment screw (F) with the

raised keys (edges) of the washer facing down.

IMPORTANT: Usethe DISENGAGE position only when the engineis not running. Before starting the engine,the WheelGear Levermust be placedin the ENGAGEposition (see Section3 for details).

STEP3: ATTACHREVERSECLUTCH

CONTROLCABLE

1.Carefully unwrap the reverseclutch control cable (H, Figure 2-6) from its ship- ping position and route it upalong the in- side edgeof the left side handlebar.A knob and large hex nut (I) is installed on the ca- ble.

Left Side Reverse Clutch

Handlebar Control Knob

Figure2-7: Forward ClutchControllevers (J). Forwarddutch control linkage (K).

2.The forward clutch control cable (with attached spring) is hanging loosely near the right-side wheel. Beingcareful not to kink or stretch the cable,insert the z-con- nector (L, Figure 2-8 - end of the spring) into the hole at the end of the forward clutch control linkage (K, Figure 2-7).

6. Threadthe height adjustment screw (F,

Figure 2-3) into the hole in the handlebar

cross-brace, making sure that the raised

keys on the washer fit into the slot on the

height adjustment bracket. Tightenthe

height adjustment screw securely. Next,

Slot in ControlPanel

'1

securely tighten the two screws and nuts

in the ends of the handlebar (M, Figure 2-

3).

7.To removethe tiller from its shipping platform, first carefully unwrap the wheel gearcable (with attached lever- see Figure 2-5) from around the chassis. Movethe Wheel GearLever (G) to the DISENGAGE position--this allows the wheelsto rotate freely. Usethe handlebarsto roll the tiller off the platform.

Figure2-6:Attachreverseclutchcontrolas-semblytodotted holein handlebarpanel.

2.Insert the cable into the slot in the con- trol paneland fit the threaded assembly into the holein the slot (seeFigure2-6). Be sure that the flat side of the threaded as- sembly is aligned with the flat side of the hole. Slide the hex nut (I) upthe cable and tighten it securely.

3.Testthe function of the reverseclutch control cable by pulling the knob out and releasing it. The knob should return to its neutral position againstthe tapered bush- ing. If it doesn't,contact your local dealer or the factory for technical.

STEP4: ATTACHFORWARDCLUTCH

CONTROLCABLE

Figure2-8

3.Attach the cable adjuster (A, Figure2-9) to the bracket on the right-side handlebar. Usetwo 1/2"wrenches to loosen the two

jam nuts (B)just enoughto slide the cable adjuster onto the bracket. Then handtight- enthe jam nuts.

1. Removeany fasteners (rubber bands, tape, etc.) that may securethe Forward Clutch Control levers (J, Figure 2-7) to the handlebar.

Figure2-5: CarefullyunwrapWheelGearLe- verand moveleverto DISENGAGE.

NOTE: The Wheel Gear Lever will be	Figure2-9
installed later in this procedure.