Polaris 145, 140 owner manual Assemble the Cleaner

•For dedicated suction line installations, adjust valve in equipment area that controls water flow to suction line until indicator is within the target area. Mark valves for reference.

•For skimmer installations, turn knob on flow regulator clockwise until indicator is within the target area. If the indicator does not move into the target area, remove the flow regulator and connect hose directly.

If too much flow:

•For dedicated suction line installations, adjust valve in equipment area that controls water flow to suction line until the indicator is within the target area.

•For skimmer installations, turn knob on flow regulator counterclockwise until indicator is within target area. If knob is turned all the way, open the main drain (or a second skimmer) until indicator is within target area.

5. Turn off pump. Hold hose underwater and remove flow indicator.

English

Assemble the Cleaner

4	1.	Install steering skirt onto bottom of
		cleaner, lining up tab on skirt with
		notch on cleaner. Logos on
		steering skirt and cleaner should
		be on the same side.
	2.	Pull the surface disk onto the cleaner.
	3.	Select the white shoe for vinyl
		liner, fiberglass and tile pools and
		the gray shoe for all other
		installations. Install shoe by sliding it
		onto cleaner bottom and pulling lip

Deflector Ring

Swivel

Steering

	onto cleaner to lock.
4.	Slide deflector ring onto hose and
	secure cuff. To reposition deflector
	ring, remove it from the hose; do
	not slide it.
	Do not use the deflector ring in a
	fiberglass pool.
5.	Fill hose completely with water.
6.	Submerge Polaris and remove any
	air in the cleaner by rotating it in all
	directions.
7.	With the hose and pool cleaner
	underwater, connect hose to swivel.
8.	Turn on pool pump.

Skirt

Surface Disk

Shoe

Logos

www.polarispool.com