Polaris 280 owner manual Assemble the Cleaner, Check for Proper RPM, If count is less than 28 RPM

Page 5

3

Assemble the Cleaner

 

 

1.

Use the nut to attach the feed hose to

 

 

the feed pipe.

 

2.

Pull out the bag and attach the bag

 

 

collar to the feed hose.

 

3.

Position the head float 1/2 to 1 inch

 

 

back from feed pipe.

 

4.

Turn on the pool filtration pump and

 

 

allow it to prime before turning on the

 

 

booster pump.

Bag Collar

Head

Float

Hose Nut

Feed Pipe

English

Check for Proper RPM

4

Before operating the Polaris, check for proper wheel revolutions per minute (RPM). For

maximum efficiency, the Polaris should operate between 28 and 32 RPM.

1.

Mark the single-wheel

Single-wheel side

 

 

side tire.

 

 

 

2.Turn pump on, hold cleaner below water level and count wheel revolutions for 1 minute.

If count is less than 28 RPM:

Check the filter screen in the in-line filter for debris that restricts water flow.

Sweep Hose

Clean the skimmer, filter and pump basket, clearing debris that restricts water flow.

Check the hoses, connections and swivels for leaks that cause loss of water pressure.

Remove the blue restrictor disk from the UWF.

If an adjustable gate valve is installed on the booster pump or cleaner line, open it completely so water can flow freely to the Polaris.

If count is more than 32 RPM:

Replace the blue restrictor disk in the UWF with the red restrictor. If the flow is still too high, unscrew the pressure relief valve until the proper RPM is reached. Note: The pressure relief valve should only be adjusted when a restrictor is installed.

If an adjustable valve is installed after the booster pump, adjust it to reduce the water flow to the cleaner.

www.polarispool.com

Image 5
Contents N U a L US and Canada For customer service or supportAlways remove the Polaris before swimmers enter the pool Introduction Polaris 280 Complete CleanerAdjust Feed Hose To Fit Pool Length Quick Installation InstructionsInstall the Universal Wall Fitting Check for Proper RPM Assemble the CleanerIf count is less than 28 RPM If count is more than 32 RPMRoutine Maintenance Fine Tuning The Polaris CleanerEnglish Description Action Polaris does not back up TroubleshootingAction Polaris only turns in one direction Action Feed hose becomes tangledTroubleshooting Worksheet Page Informations importantes Service clientèle ou assistance techniquePolaris 280 complets Installation du raccord mural universel UWF Instructions d’installation rapideContrôle de la vitesse de rotation de la roue Assemblage du nettoyeurSi elle est inférieure à 28 t/min Si la vitesse est supérieure à 32 tr/minEntretien normal Réglage fin du nettoyeur PolarisVue éclatée Français Action Le Polaris ne tourne que dans un seul sens DépannageAction Le Polaris ne recule pas Action Le nettoyeur tourne en rond Couché sur le côté Action Le tuyau darrivée forme des nœudsAction Le nettoyeur ne nettoie pas toute la piscine Page Kundendienst Wichtige InformationenPolaris 280 kompletter Reiniger EinleitungZufuhrschlauch passend zur Länge des Pools einstellen Quick InstallationsanleitungInstallation der universalen Wandhalterung Umdrehungszahl der Räder überprüfen Montage des ReinigersBei weniger als 28 Umdrehungen pro Minute Bei mehr als 32 Umdrehungen pro MinuteRoutine Wartung Feineinstellung des Polaris ReinigersExplosionsdarstellung Deutsch Vorgang Polaris Rücklauf funktioniert nicht FehlerbehebungVorgang Der Zufuhrschlauch verwickelt sich Vorgang Der Polaris dreht sich nur in eine RichtungVorgang Der Sweep-Schlauch wird in das Saugrohr gesaugt Vorgang Der Reiniger reinigt nicht den gesamten PoolPage Atención a clientes o apoyo técnico Información importanteLimpiafondos completo Polaris IntroducciónAjuste la manguera alimentadora al tamaño de la piscina Instrucciones para la instalación rápidaInstale el conector universal de pared Compruebe las RPM de la rueda Arme el limpiafondosSi gira a menos de 28 RPM Si gira a más de 32 RPMMantenimiento periódico Ajustes menores del limpiafondos PolarisDiagrama expandido de piezas No. No. pieza Descripción Cant Acción El Polaris gira siempre en el mismo sentido Resolución de problemasAcción El Polaris no retrocede Acción El limpiafondos está de lado, girando en círculos Acción La manguera alimentadora se atascaAcción El limpiafondos no limpia toda la piscina Page Per assistenza clienti o supporto Informazioni importantiIl dispositivo di pulizia completo Polaris IntroduzioneInstallazione del raccordo a parete universale Istruzioni per una rapida installazioneRegolazione della lunghezza del tubo di alimentazione Modo che si adatti a quella della piscinaMontaggio del dispositivo di pulizia Controllo dell’RPM delle ruoteManutenzione regolare Ottimizzazione della messa a punto del PolarisSchema esploso dei pezzi Italiano Azione il Polaris si gira solo in una direzione Individuazione e soluzione dei problemiAzione il Polaris non va in retromarcia Azione il tubo di alimentazione si ingarbuglia Page Informações importantes Aspirador completo Polaris IntroduçaoInstale a conexão universal de parede Instruções para instalação rápidaAjuste a mangueira de alimentação de acordo com o Comprimento da piscinaVerifique se a rotação da roda rpm está correcta Monte o aspiradorManutenção de rotina Regular o aspirador PolarisDiagrama das peças Peça no Descrição Acção O Polaris só se desvia numa direcção Identificação e correcção de problemasAcção O Polaris não recua Acção O aspirador gira em círculos sobre a sua parte lateral Page EC Declaration of Conformity

280 specifications

The Polaris 280 is a highly regarded robotic pool cleaner engineered for efficiency and performance. Its innovative design makes it a popular choice among pool owners seeking a reliable cleaning solution. The Polaris 280 operates with a unique yet effective pressure-side cleaning system that utilizes the force of water to capture dirt, debris, and leaves from all surfaces of your pool, including the floor and walls.

One of the standout features of the Polaris 280 is its dual drive jet system, which powers its agile movement throughout the pool. This feature allows the unit to cover a large area quickly and efficiently, ensuring that the entire pool is clean in no time. The robust construction of the Polaris 280 is another highlight; it boasts a durable body designed to withstand harsh pool conditions, including exposure to chemicals and varying water temperatures.

The Polaris 280 is equipped with a powerful, high-efficiency filter bag that captures fine debris and dirt particles. The filter bag is easy to access and clean, promoting convenient maintenance and optimal performance. The model also features a 31-foot hose, which provides ample reach for most pool sizes, minimizing the need for additional extensions or adjustments.

Another significant characteristic of the Polaris 280 is its use of advanced technology to enhance its cleaning capabilities. The cleaner employs a patented back-up valve that allows it to reverse direction when encountering obstacles. This functionality minimizes stuck situations, ensuring uninterrupted cleaning and efficient navigation throughout the pool.

The Polaris 280 operates independently of the pool’s filtration system, allowing for significant water circulation and improving overall water quality. As a result, users can enjoy a cleaner swimming environment with less manual effort in maintaining pool hygiene.

Additionally, its easy installation process means that pool owners can set it up without requiring professional assistance. The Polaris 280 has also gained recognition for its reliability and effectiveness, with many satisfied users praising its performance and longevity.

In conclusion, the Polaris 280 is a powerful robotic pool cleaner combining advanced features, durable construction, and user-friendly operation. Its ability to efficiently clear debris while improving overall pool circulation makes it a top choice for pool maintenance enthusiasts. Whether you have an inground or above-ground pool, the Polaris 280 delivers a comprehensive cleaning experience tailored to meet your needs.