Genie Z-34, Z-22N manual Maintenance, Observe and Obey, Check the Hydraulic Oil Level

Page 14

Operator's Manual	Second Edition • Ninth Printing

Maintenance

Observe and Obey:

Only routine maintenance items specified in this manual shall be performed by the operator.

Scheduled maintenance inspections shall be completed by qualified service technicians, according to the manufacturer's specifications and the requirements specified in the responsibilities manual.

Maintenance Symbols Legend

The following symbols have been used in this manual to help communicate the intent of the instructions. When one or more of the symbols appear at the beginning of a maintenance procedure, it conveys the meaning below.

Indicates that tools will be required to perform this procedure.

Indicates that new parts will be required to perform this procedure.

Check the Hydraulic Oil Level

Maintaining the hydraulic oil at the proper level is essential to machine operation. Improper hydraulic oil levels can damage hydraulic components. Daily checks allow the inspector to identify changes in oil level that might indicate the presence of hydraulic system problems.

1Be sure that the boom is in the stowed position.

2Check the hydraulic oil level.

Result: The hydraulic oil level should be at the FULL mark on the dipstick or visible in the sight glass or between the FULL and ADD marks on the hydraulic tank.

3 Add hydraulic oil if necessary.

Hydraulic Oil Specifications

Hydraulic oil type	Refer to machine decal

12

Genie Z-34/22 & Genie Z-34/22N

Part No.43654

Image 14

Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsMaximum slope rating, stowed position Fall Hazards Collision Hazards Bodily Injury Hazard Component Damage HazardDamaged Machine Hazards Decal LegendExplosion Hazards Battery Safety Burn HazardsComponent Damage Hazards Lifting HazardControls Platform Control PanelGround Control Panel Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionObserve and Obey MaintenanceMaintenance Symbols Legend Check the Hydraulic Oil LevelScheduled Maintenance Check the BatteriesTest Emergency Stop Function TestsAt the Ground Controls At the Platform Controls Test Drive and Braking Test Machine FunctionsTest the Steering Test the Drive Enable System Test Limited Drive SpeedMachines without lift/drive select switch Workplace Inspection Workplace InspectionOperating Instructions Only use the machine as it was intendedOperation from Ground Emergency StopAuxiliary Controls To Position PlatformTo Drive Operation from PlatformTo Steer Driving on a slope To determine the slope gradeDriving down a slope Driving Up/Down Slopes Drive/Brake Control TheoryDriving up a slope After Each Use Drive EnableLow Battery Indicator Light Dry Battery Filling Charging Instructions Battery and Charger Instructions Observe and ObeyTo Charge Battery Free-wheel Configuration for Winching Transport & Lifting InstructionsSecuring the Platform Securing to Truck or Trailer for TransitSecuring the Chassis Lifting Instructions Decals Decal InspectionGround Controls Side Chassis Platform Power Unit Specifications Drive speeds maximumBooms Mph Km/h Raised or extended 40 ft/40 sec 12.2 m/40 sec Genie Scandinavia