Operator's Manual | Second Edition • Ninth Printing |
|
|
|
|
OPERATING INSTRUCTIONS
Operation from Platform
1Turn the key switch to platform control.
2Pull out both ground and platform red Emergency Stop buttons to the on position.
3Be sure that both battery packs are connected before operating the machine.
To Position Platform
1Set the boom function speed controller to the desired speed.
Note: Drive and steer functions are not affected by the boom function speed controller.
2Move the lift/drive select switch to the lift position (if equipped).
3Press down the foot switch.
4Move the appropriate toggle switch according to the markings on the control panel.
Machines equipped with Platform Level Control Disable Function: The platform level toggle switch will not operate when the boom is raised past the drive speed limit switch.
To Steer
1Move the lift/drive select switch to the drive position (if equipped).
2Press down the foot switch.
3Turn the steer wheels with the thumb rocker switch located on top of the drive control handle.
Use the
To Drive
1Move the lift/drive select switch to the drive position (if equipped).
2Press down the foot switch.
3Increase speed: Slowly move the drive control handle off center.
Decrease speed: Slowly move the drive control handle toward center.
Stop: Return the drive control handle to center or release the foot switch.
Use the
The travel alarm will sound when the drive controller is moved off center.
Note: When the turntable is rotated so the boom is past the
Machine travel speed is restricted when the booms are raised or extended.
Battery condition will affect the ability of the machine to climb a slope.
22 | Genie | Part No.43654 |