Second Edition • Ninth Printing | Operator's Manual |
|
|
|
|
Collision Hazards
Be aware of limited sight distance and blind spots when driving or operating.
Be aware of boom position when rotating the turntable.
The machine must be on a level surface or secured before releasing the brakes.
Do not drive the machine with the brakes released. If the travel alarm sounds when not driving, the brakes are released.
Check work area for overhead obstructions or other possible hazards.
Be aware of crushing hazards when grasping the platform guard rail.
It is recommended that operators wear an approved hard hat when operating the machine.
Observe and use the
Do not operate a boom in the path of any crane unless the controls of the crane have been locked out and/or precautions have been taken to prevent any potential collision.
No stunt driving or horseplay while operating a machine.
SAFETY RULES
Do not lower the boom unless the area below is clear of personnel and obstructions.
Limit travel speed according to the condition of the ground surface, congestion, slope, location of personnel, and any other factors which may cause collision.
Use extreme care and slow speeds while driving the machine in the stowed position on any slope.
Do not drive on a slope with boom raised.
Do not allow the machine speed on any slope to exceed 3 mph / 4.8 km/h (walking pace).
Stop the machine by returning the drive control handle to the center position or releasing the foot switch.
When stopped on a slope, the machine may initially move slightly downhill when the drive control handle is moved to drive up the slope. Be sure the area behind the machine is clear.
Do not drive on a slope with the wheels turned. Be sure the wheels are aligned up and down the slope.
Always use a winch to load and unload a machine from a transport vehicle.
Part No.43654 | Genie | 5 |