Delta Electronics ASDA-AB manual Display Flowchart, Keypad Operation

Chapter 4 Display and OperationASDA-AB Series

4.2Display Flowchart

Figure 4.2 Keypad Operation

1.When the power is applied to the AC servo drive, the LCD display will show the monitor function codes for approximately one second, then enter into the monitor mode.

2.In monitor mode, pressing UP or DOWN arrow key can switch monitor parameter code. At this time, monitor display symbol will display for approximately one second.

3.In monitor mode, pressing MODE key can enter into parameter mode, pressing the SHIFT key can switch parameter group and pressing UP or DOWN arrow key can change parameter group code.

4.In parameter mode, the system will enter into the setting mode immediately after the Set key is pressed. The LCD display will display the corresponding setting value of this parameter simultaneously. Then, users can use UP or DOWN arrow key to change parameter value or press MODE key to exit and return back to the parameter mode.

5.In parameter setting mode, the users can move the cursor to left by pressing the SHIFT key and change the parameter settings (blinking digits) by pressing the UP or DOWN arrow key.

6.After the setting value change is completed, press SET key to save parameter settings or execute command.

7.When the parameter setting is completed, LCD display will show the end code “-END-“ and automatically return back to parameter mode.

4-2 Revision January 2009