Genie Z-34, Z-22N manual Controls, Platform Control Panel

Page 10

Operator's Manual	Second Edition • Ninth Printing

Controls

Platform Control Panel

1Drive enable switch

2Drive enable indicator light

3Auxiliary power switch

4Platform level switch

5Horn button

6Primary boom extend/retract switch

7Red Emergency Stop button

8Not used

9Battery charge indicator and/or low voltage interrupt (option)

10Proportional control handle for drive function and thumb rocker for steer function

11Boom function speed controller

12Jib boom up/down switch

13Low battery indicator light

14Secondary boom up/down switch

15Primary boom up/down switch

16Turntable rotate switch

17Platform rotate switch

8

Genie Z-34/22 & Genie Z-34/22N

Part No.43654

Image 10

Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsMaximum slope rating, stowed position Fall Hazards Collision Hazards Bodily Injury Hazard Component Damage HazardDamaged Machine Hazards Decal LegendExplosion Hazards Battery Safety Burn HazardsComponent Damage Hazards Lifting HazardControls Platform Control PanelGround Control Panel Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionObserve and Obey MaintenanceMaintenance Symbols Legend Check the Hydraulic Oil LevelScheduled Maintenance Check the BatteriesAt the Ground Controls Function TestsTest Emergency Stop At the Platform Controls Test the Steering Test Machine FunctionsTest Drive and Braking Test the Drive Enable System Test Limited Drive SpeedMachines without lift/drive select switch Workplace Inspection Workplace InspectionOperating Instructions Only use the machine as it was intendedOperation from Ground Emergency StopAuxiliary Controls To Position PlatformTo Steer Operation from PlatformTo Drive Driving on a slope To determine the slope gradeDriving up a slope Driving Up/Down Slopes Drive/Brake Control TheoryDriving down a slope Low Battery Indicator Light Drive EnableAfter Each Use To Charge Battery Battery and Charger Instructions Observe and ObeyDry Battery Filling Charging Instructions Free-wheel Configuration for Winching Transport & Lifting InstructionsSecuring the Chassis Securing to Truck or Trailer for TransitSecuring the Platform Lifting Instructions Decals Decal InspectionGround Controls Side Chassis Platform Power Unit Specifications Drive speeds maximumBooms Mph Km/h Raised or extended 40 ft/40 sec 12.2 m/40 sec Genie Scandinavia