Genie Z-34, Z-22N manual Fall Hazards

Page 6

Operator's Manual

Second Edition • Ninth Printing

 

 

 

 

SAFETY RULES

Do not place or attach overhanging loads to any part of this machine.

Do not place ladders or scaffolds in the platform or against any part of this machine.

Do not use the machine on a moving or mobile surface or vehicle.

Be sure all tires are in good condition and lug nuts are properly tightened.

Do not use batteries that weigh less than the original equipment. Batteries are used as counterweight and are critical to machine stability. Each battery must weigh 88 lbs / 40 kg. Each battery box including batteries must weigh a minimum of 452 lbs / 205 kg.

Do not use the machine as a crane.

Do not push the machine or other objects with the boom.

Do not contact adjacent structures with the boom.

Do not tie the boom or platform to adjacent structures.

Do not place loads outside the platform perimeter.

Fall Hazards

Occupants must wear a safety belt or harness and comply with applicable governmental regulations. Attach lanyard to the anchor provided in the platform.

Do not sit, stand or climb on the platform guard rails. Maintain a firm footing on the platform floor at all times.

Do not climb down from the platform when raised.

Keep the platform floor clear of debris.

Lower the platform entry mid-rail or close the entry gate before operating.

4

Genie Z-34/22 & Genie Z-34/22N

Part No.43654

Image 6
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsMaximum slope rating, stowed position Fall Hazards Collision Hazards Bodily Injury Hazard Component Damage HazardDamaged Machine Hazards Decal LegendExplosion Hazards Battery Safety Burn HazardsComponent Damage Hazards Lifting HazardControls Platform Control PanelGround Control Panel Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionObserve and Obey MaintenanceMaintenance Symbols Legend Check the Hydraulic Oil LevelScheduled Maintenance Check the BatteriesFunction Tests At the Ground ControlsTest Emergency Stop At the Platform Controls Test Machine Functions Test the SteeringTest Drive and Braking Test the Drive Enable System Test Limited Drive SpeedMachines without lift/drive select switch Workplace Inspection Workplace InspectionOperating Instructions Only use the machine as it was intendedOperation from Ground Emergency StopAuxiliary Controls To Position PlatformOperation from Platform To SteerTo Drive Driving on a slope To determine the slope gradeDriving Up/Down Slopes Drive/Brake Control Theory Driving up a slopeDriving down a slope Drive Enable Low Battery Indicator LightAfter Each Use Battery and Charger Instructions Observe and Obey To Charge BatteryDry Battery Filling Charging Instructions Free-wheel Configuration for Winching Transport & Lifting InstructionsSecuring to Truck or Trailer for Transit Securing the ChassisSecuring the Platform Lifting Instructions Decals Decal InspectionGround Controls Side Chassis Platform Power Unit Specifications Drive speeds maximumBooms Mph Km/h Raised or extended 40 ft/40 sec 12.2 m/40 sec Genie Scandinavia