Genie Z-34, Z-22N manual Ground Control Panel

Page 11

Second Edition • Ninth Printing	Operator's Manual

CONTROLS

Ground Control Panel
1	Turntable rotate switch	8	Red Emergency Stop button
2	Platform rotate switch	9	10A breaker for electrical circuits
3	Platform level switch	10	Remote brake release
4	Primary boom extend/retract switch	11	Not used
5	Auxiliary power switch	12	Jib boom up/down switch
6	Hour meter	13	Primary boom up/down switch
7	Key switch for platform/off/ground selection	14	Function enable switch
		15	Secondary boom up/down switch

Part No.43654

Genie Z-34/22 & Genie Z-34/22N

9

Image 11

Contents Operator’s Manual Contact us ContentsDo Not Operate Unless Safety RulesTip-over Hazards Electrocution HazardsMaximum slope rating, stowed position Fall Hazards Collision Hazards Decal Legend Component Damage HazardDamaged Machine Hazards Bodily Injury HazardLifting Hazard Battery Safety Burn HazardsComponent Damage Hazards Explosion HazardsPlatform Control Panel ControlsGround Control Panel Fundamentals Pre-operation InspectionPRE-OPERATION Inspection Pre-operation InspectionCheck the Hydraulic Oil Level MaintenanceMaintenance Symbols Legend Observe and ObeyCheck the Batteries Scheduled MaintenanceTest Emergency Stop Function TestsAt the Ground Controls At the Platform Controls Test Drive and Braking Test Machine FunctionsTest the Steering Test Limited Drive Speed Test the Drive Enable SystemMachines without lift/drive select switch Workplace Inspection Workplace InspectionOnly use the machine as it was intended Operating InstructionsTo Position Platform Emergency StopAuxiliary Controls Operation from GroundTo Drive Operation from PlatformTo Steer To determine the slope grade Driving on a slopeDriving down a slope Driving Up/Down Slopes Drive/Brake Control TheoryDriving up a slope After Each Use Drive EnableLow Battery Indicator Light Dry Battery Filling Charging Instructions Battery and Charger Instructions Observe and ObeyTo Charge Battery Transport & Lifting Instructions Free-wheel Configuration for WinchingSecuring the Platform Securing to Truck or Trailer for TransitSecuring the Chassis Lifting Instructions Decal Inspection DecalsGround Controls Side Chassis Platform Power Unit Drive speeds maximum SpecificationsBooms Mph Km/h Raised or extended 40 ft/40 sec 12.2 m/40 sec Genie Scandinavia