Genie GS-2668 RT, GS-3268 RT manual Auto Level Outriggers if equipped, Fall Protection

Page 26

Operator's Manual

Second Edition · Third Printing

 

 

 

 

OPERATING INSTRUCTIONS

Auto Level Outriggers (if equipped)

These instructions apply to machines with the black auto level outrigger control box.

1Position the machine below the desired work area.

2 Pull out the red Emergency Stop buttons at the ground and platform controls.

3Push and hold the auto level button.

4Activate the outrigger up/down toggle switch in the down direction.

Result: The outriggers will extend and level the machine. A beep will sound when the machine is level.

The red indicator light above the lift symbol on the outrigger control panel comes on when one but not all outriggers are down. All drive and lift functions are disabled.

The light turns off when all outriggers are in firm contact with the ground. The drive function is disabled while the outriggers are down.

To control individual outriggers

1 Push and hold the outrigger function enable button.

2 Push and hold an outrigger button.

3 Activate the outrigger up/down toggle switch in the desired direction to level the machine.

Positioning machine on a slope

When setting the machine up on a slope, the steer- end outriggers must be lowered first.

Fall Protection

Personal fall protection equipment (PFPE) is not required when operating this machine. If PFPE is required by job site or employer rules, the following shall apply:

All PFPE must comply with applicable governmental regulations and must be inspected and used in accordance with the manufacturer’s instructions.

24

Genie GS-2668 RT & Genie GS-3268 RT

Part No. 82233

Image 26
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessMaximum capacity GS-2668RT Electrocution HazardsTip-over Hazards Maximum capacity GS-3268RTSafety Rules GS-2668 RT GS-3268 RTFall Hazards Collision Hazards Damaged Machine Hazards Component Damage HazardsExplosion and Fire Hazards Decal Legend Crushing HazardsBodily Injury Hazard Page Controls Ground Control Panel Controls Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionObserve and Obey MaintenanceMaintenance Symbols Legend Check the Engine Oil LevelHydraulic oil specifications Check the Hydraulic Oil Level Check the BatteriesScheduled Maintenance Check the Engine Coolant LevelTest Emergency Stop Function TestsAt the Ground Controls Test the Up/Down FunctionsTest the Manual Lowering Test the Up/Down Functions and the Function Enable SwitchesAt the Platform Controls Test the HornTest the Tilt Sensor Operation Test Drive and BrakingTest Limited Drive Speed Workplace Inspection Workplace InspectionStarting the Engine Operating InstructionsEmergency Stop Only use the machine as it was intendedOperation From Ground Operation From PlatformAfter Each Use Operation From Ground with ControllerEngine Stop Button To control individual outriggers Auto Level Outriggers if equippedFall Protection Positioning machine on a slopeBrake Release Operation Transport InstructionsSecuring to Truck or Trailer for Transit Part No. Description Quantity DecalsDecal Inspection Additional decals Model GS-2668 RT SpecificationsPlatform dimensions Drive speedsSpecifications Model GS-3268 RT+34