Genie GS-2668 RT, GS-3268 RT At the Platform Controls, Test the Manual Lowering, Test the Horn

Page 20

Operator's Manual

Second Edition · Third Printing

 

 

 

 

FUNCTION TESTS

9Push and hold the function enable button and activate the platform up function.

Result: The platform should raise.

10Push and hold the function enable button and activate the platform down function.

Result: The platform should lower. The descent alarm should sound while the platform is lowering.

Test the Manual Lowering

11Push and hold the function enable button and raise the platform approximately 2 feet / 60 cm.

12Push in the red Emergency Stop button to shut off the engine.

13Pull out the red Emergency Stop button to the on position.

14Push and hold the function enable button. Activate the down function.

Result: The platform should lower. The descent alarm will not sound.

15Turn the key switch to platform control and restart the engine.

At the Platform Controls

Test Emergency Stop

16Push in the platform red Emergency Stop button to the off position.

Result: No functions should operate.

17Pull the red Emergency Stop button out to the on position.

Result: The green power light should come on.

Test the Horn

18 Push the horn button.

Result: The horn should sound.

Test the Up/Down Functions and the Function Enable Switches

19Start the engine.

20Activate the platform up function.

Result: The platform should not raise.

21Push and hold a function enable/speed select button.

22Activate the platform up function.

Result: The platform should raise.

23 Release the function enable button.

Result: The platform should stop raising.

24Push and hold a function enable/speed select button. Activate the platform down function.

Result: The platform should lower. The descent alarm should sound while the platform is lowering.

Test the Steering

Note: When performing the steer and drive function tests, stand in the platform facing the steer end of the machine.

25Press and hold the function enable switch.

26Depress the thumb rocker switch on top of the control handle in the direction identified by the blue triangle on the control panel.

Result: The steer wheels should turn in the direction that the blue triangle points on the control panel.

18

Genie GS-2668 RT & Genie GS-3268 RT

Part No. 82233

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsMaximum capacity GS-2668RT Maximum capacity GS-3268RTSafety Rules GS-2668 RT GS-3268 RTFall Hazards Collision Hazards Damaged Machine Hazards Component Damage HazardsExplosion and Fire Hazards Decal Legend Crushing HazardsBodily Injury Hazard Page Controls Ground Control Panel Controls Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionMaintenance Maintenance Symbols LegendObserve and Obey Check the Engine Oil LevelHydraulic oil specifications Check the Hydraulic Oil Level Check the BatteriesScheduled Maintenance Check the Engine Coolant LevelFunction Tests At the Ground ControlsTest Emergency Stop Test the Up/Down FunctionsTest the Up/Down Functions and the Function Enable Switches At the Platform ControlsTest the Manual Lowering Test the HornTest the Tilt Sensor Operation Test Drive and BrakingTest Limited Drive Speed Workplace Inspection Workplace InspectionOperating Instructions Emergency StopStarting the Engine Only use the machine as it was intendedOperation From Ground Operation From PlatformAfter Each Use Operation From Ground with ControllerEngine Stop Button Auto Level Outriggers if equipped Fall ProtectionTo control individual outriggers Positioning machine on a slopeBrake Release Operation Transport InstructionsSecuring to Truck or Trailer for Transit Part No. Description Quantity DecalsDecal Inspection Additional decals Specifications Platform dimensionsModel GS-2668 RT Drive speedsSpecifications Model GS-3268 RT+34
Top Page Image Contents