Generac 004702-0, 004703-0, 004704-0, 004705-0, 004706-0, 004707-0 owner manual Testing Under Load

Page 37

Section 7 – Post Installation

QUIETPACT 55, 65, and 75 Recreational Vehicle Generators

7.4TESTING UNDER LOAD

Apply electrical loads equal to about 75 to 100 per- cent of the unit's rated wattage/amperage capacity.

Let the unit run at least 30 minutes with load applied. During this part of the test, check that the unit is not running excessively hot and that adequate cooling airflow is available. You must not allow the unit to overheat during prolonged operation.

NOTE:

◆OPTIONAL LP GAS FUEL SYSTEM

❑Fuel system is properly installed and checked for leaks.

❑Pressure at regulator inlet is correct.

❑Rated flow of primary regulator is correct.

❑All parts are properly installed.

❑Fuel system is properly tested/adjusted.

The generator engine is equipped with a high tem- perature switch. The switch has normally open (N.O.) contacts. When the engine temperature is too high, switch contacts close, and the engine shuts down automatically.

GENERAC RECOMMENDS THAT YOU TEST THE GENERATOR FOR ADEQUATE COOLING.

7.5INSTALLATION CHECKLIST

◆LOCATION AND SUPPORT

❑Generator is properly located.

❑Generator is properly supported.

❑Generator is properly restrained.

◆EXHAUST SYSTEM

❑Exhaust system complies with all applicable codes.

❑Exhaust system is properly and safely installed.

◆ELECTRICAL CONNECTIONS

❑Connections comply with local code requirements and all National Electrical Codes.

❑Junction box is properly installed.

❑Wiring meets all standards.

❑All connections are correct.

❑Conduit is properly installed and sealed.

❑Generator is properly bonded to the vehicle.

◆ GENERATOR COMPARTMENT

 

◆ BATTERY INSTALLATION

❑ Compartment construction is proper.

 

❑ Recommended battery is installed.

❑ Holes/Openings are vapor-sealed.

 

❑ Recommended cables are installed.

❑ Compartment size is correct.

 

❑ Cables are clean and tight.

❑ Compartment is vapor-sealed.

 

❑ Cables are connected properly.

❑ Sound insulation is correct.

 

❑ Proper ventilation is provided.

❑ Floor cutouts are properly completed.

 

❑ Terminals are coated with anti-corrosion grease,

 

 

and terminal covers are positioned.

◆COOLING AND VENTILATING AIR

❑Airflow is adequate.

❑Air inlet opening is correct.

❑Compensate for restrictions.

❑Check that installation has been tested.

◆GASOLINE FUEL SYSTEM

❑Fuel tank complies with all applicable codes.

❑Fuel system is properly installed and checked for leaks.

◆OPTIONAL ACCESSORIES

❑Check that remote start/stop panels (if used) are installed properly.

❑Check that hourmeter kit (if used) is installed properly.

❑Check that any other options and accessories (if used) are installed properly.

◆POST INSTALLATION TESTS

❑Check that all tests are completed properly.

DATE OF INSTALLATION ____________________________________________________

NAME OF INSTALLER ______________________________________________________

SIGNATURE OF INSTALLER ________________________________________________

Generac® Power Systems, Inc. 35

Page 36 Page 38
Image 37
Page 36 Page 38
Contents This manual should remain with the unit Introduction Authorized Service Dealer LocationTable of Contents General Hazards Electrical Hazards Reference Number Identification Generator IdentificationSafety InstallationGenerator Applicability Generator AC Connection System1.1 Fuel Consumption gph/lbs.ph SpecificationsFuel Requirements Gasoline Generator Control Panel Automatic Choke Optional Remote START/STOP PanelBefore Starting the Engine Stopping the Generator Starting the GeneratorLetting the Engine Stabilize LOW OIL Pressure Switch High Temperature SwitchProtection Systems Field BoostOvervoltage Protection Checking the Engine OIL Level6 25-HOUR CHECK-UP 5 25-HOUR BREAK-IN PeriodCleaning the Foam Precleaner Maintaining the Engine AIR CleanerChanging the Engine OIL AND/OR OIL Filter Checking the Engine Spark Plug Clean Spark ArrestorBattery Maintenance Cleaning the GeneratorWeekly Every SIX MonthsRV Generator Service Interval OUT of Service ProcedureDrive Belt Exercising the GeneratorQuietpact 55, 65, and 75 Recreational Vehicle Generators Part General Hazards Electrical Hazards Standards Booklets Purpose and Scope Installation InstructionsEquipment Description Generator Engine Operating SpeedDimensions Drawing No E1058-A Generator Location Location and SupportSuspended Mounting Generator CompartmentsCompartment Size Generator RestraintTypical Compartment Construction Sound Insulating MaterialsAcoustics Cooling and Ventilating AIRCompartment Floor Cutouts Generator AirflowGasoline Fuel System Testing the InstallationGenerator Fuel Supply Line LP GAS Fuel SystemParts not Included in Fuel System Some Important Considerations Primary RegulatorVapor Withdrawal Gaseous CarburetionFuel Supply Lines Exhaust SystemLeakage Tests Excess Flow ValveElectrical Connections Exhaust System SafetyMufflers and Spark Arrestors Electrical Junction BOXIsolating Different Power Sources WiringPower Supply Cord Generator AC ConnectionsRecommended Battery Battery InstallationBattery Cables Battery Cable Connections18 Transfer Switch Isolation Method Post Installation Tests Optional AccessoriesBefore Initial START-UP Initial StartInstallation Checklist Testing Under LoadProblem Cause Correction Troubleshooting GuideQuietpact 55, 65, and 75 Recreational Vehicle Generators Battery Supplied by Customer 12V Battery 19 18 Part NO. QTY Description View a QTY Description 105 Screw Hhtt M6-1.0 X 10 YC 28,2 Circuit Breaker 3 X 15A 15B ASSEMBLY, Crankcase RV Exploded Views and Parts Lists CASTING, Twin Regulator Housing MANUFACTURER’S Emission Control System Warranty Coverage Your Warranty Rights and ObligationsPURCHASER’S/OWNER’S Warranty Responsibilities Emission Related Parts Include the Following Emission Control System WarrantyWarranty Schedule CONSUMER/PERSONAL Applications

004702-0, 004703-0, 004704-0, 004705-0, 004706-0, 004707-0 specifications

Generac has established itself as a leader in the power generation industry, particularly noted for its wide range of generators designed to provide reliable backup power. Among its various models, the Generac series consisting of the 004702-0, 004703-0, 004704-0, 004705-0, 004706-0, and 004707-0 stands out due to their dependable performance and innovative features. Each model in this series is engineered for both residential and light commercial applications, offering peace of mind during power outages.

One of the main features of these models is their state-of-the-art engine technology. Equipped with a Generac engine, these generators are designed to provide efficient, powerful performance. The engines are robust and designed to withstand extended use, ensuring that users can rely on them when needed most.

A standout feature is their Automatic Transfer Switch (ATS) capability. When the power goes out, these generators automatically switch on, providing uninterrupted power to essential appliances and systems in the home. This seamless transition is vital for maintaining safety and comfort during outages, eliminating the need for manual intervention.

Fuel efficiency is another area where these models excel. They utilize either natural gas or propane, offering flexibility in fuel choice depending on availability and preference. Their engineering is optimized for minimal fuel consumption while maximizing output, making them a cost-effective solution for power needs.

Furthermore, these models incorporate advanced monitoring and control systems. Users can conveniently monitor generator performance and status through an intuitive mobile app or control panel. This technology allows users to receive alerts and updates, ensuring they are always informed about the power situation at their location.

Noise reduction technology is also a key characteristic of this series. Generac's engineers have focused on minimizing sound output, providing a quieter operation compared to many other generators in the market. This feature is particularly beneficial for residential areas where noise can be a significant concern.

Overall, the Generac 004702-0, 004703-0, 004704-0, 004705-0, 004706-0, and 004707-0 models exemplify reliability, efficiency, and advanced engineering. Their comprehensive features and user-friendly technology make them an excellent choice for anyone seeking a dependable backup power solution.
Top Page Image Contents