Briggs & Stratton 30253 manuel dutilisation Using the Generator, System Ground, Generator Location

Page 9

OPERATION

USING THE GENERATOR

System Ground

The generator has a system ground that connects the generator frame components to the ground terminals on the AC output receptacles.The system ground is connected to the AC neutral wire (the neutral is bonded to the generator frame).

Special Requirements

There may be Federal or State Occupational Safety and Health Administration (OSHA) regulations, local codes, or ordinances that apply to the intended use of the generator. Please consult a qualified electrician, electrical inspector, or the local agency having jurisdiction.

•In some areas, generators are required to be registered with local utility companies.

•If the generator is used at a construction site, there may be additional regulations which must be observed.

Connecting to a Building’s Electrical System

Connections for standby power to a building’s electrical system must be made by a qualified electrician.The connection must isolate the generator power from utility power, and must comply with all applicable laws and electrical codes.

WARNING

Generator produces powerful voltage.

Failure to isolate generator from power utility can result in death or injury to electric utility workers due to backfeed of electrical energy.

•When using generator for backup power, notify utility company. Use approved transfer equipment to isolate generator from electric utility.

•Use a ground fault circuit interrupter (GFCI) in any damp or highly conductive area, such as metal decking or steel work.

•DO NOT touch bare wires or receptacles.

•DO NOT use generator with electrical cords which are worn, frayed, bare or otherwise damaged.

•DO NOT operate generator in the rain or wet weather.

•DO NOT handle generator or electrical cords while standing in water, while barefoot, or while hands or feet are wet.

•DO NOT allow unqualified persons or children to operate or service generator.

Generator Location

Generator Clearance

WARNING

Exhaust heat/gases can ignite combustibles, structures or damage fuel tank causing a fire.

•Keep at least 5 ft. (152 cm) clearance on all sides of generator including overhead.

Place generator in a well ventilated area, which will allow for removal of deadly exhaust gas. DO NOT place generator where exhaust gas could accumulate and enter inside or be drawn into a potentially occupied building. Ensure exhaust gas is kept away from any windows, doors, ventilation intakes or other openings that can allow exhaust gas to collect in a confined area (Figure 10). Prevailing winds and air currents should be taken into consideration when positioning generator.

WARNING

Running generator gives off carbon monoxide, an odorless, colorless, poison gas.

Breathing carbon monoxide can cause nausea, fainting or death.

•Operate generator ONLY outdoors.

•Keep exhaust gas from entering a confined area through windows, doors, ventilation intakes or other openings.

•DO NOT operate generator inside any building or enclosure (even if doors or windows are open), including the generator compartment of a recreational vehicle (RV).

Figure 10 — Generator Clearance

Typical Generator Shown

Exhaust Port

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents 030253 Table of Contents Safety RulesEquipment Description When Starting Equipment When Adding or Draining FuelWhen Operating Equipment When Transporting or Repairing EquipmentWhen Testing for Engine Spark When Adjusting or Making Repairs to Your GeneratorRocker Switch Know Your GeneratorRecoil Starter Before Starting the Engine AssemblyUnpacking the Generator Attach Handle to UnitAdd Fuel When Adding FuelFuel Tank Avoid Spilling Fuel While Removing Fuel TankFuel Shut-off Valve Make sure the vent knob is turned fully counterConnecting to a Building’s Electrical System Using the GeneratorSystem Ground Generator LocationOperating Generator Connecting Electrical LoadsStarting the Engine Do not Overload the GENERATOR. See Don’t Overload GeneratorStopping the Engine Receptacles120/240 Volt AC, 30 Amp, Locking Receptacle Volt AC, 20 Amp, Duplex ReceptaclesDont Overload Generator Power ManagementCapacity ExampleGeneral Maintenance Recommendations SpecificationsEngine Maintenance Generator MaintenanceGenerator Storage StorageEngine Storage Other Storage TipsProblem Cause Solution TroubleshootingPage Year Consumer Use Years Years orTable DES Matières Veuillez Conserver CES InstructionsDescription DE L Équipement Règles DE SécuritéLors DU Démarrage DE Léquipement Lors DE Lajout OU DE LA Vidange DU CarburantLorsque Léquipement Fonctionne Lorsque Vous Transportez OU Réparez LéquipementLors DE Tests Dallumage DU Moteur Lorsque Vous Réglez OU Réparez Votre GénérateurConnaissez Votre Générateur Bouton daération Commutateur Bascule Étiquette du numéroDe série Filtre à air Interrupteur de starter Avant LE Démarrage DU Moteur AssemblageEnlever le générateur de la boite Fixez la Poignée à lAppareil PrincipalRéservoir dessence Ajoutez de lessenceLors DE Lajout DU Carburant Bouton daérationRobinet darrivée dessence Tournez la valve dessence sur la position Off Arrêt FigureUtilisation DE LA Génératrice Emplacement de la GénératriceMise à la terre du système Branchement au système électrique dun édificeUtilisation DU Générateur Démarrage du MoteurBranchement des Charges Électriques Arrêt du Moteur Prises DE CourantPrise à Verrouillage de 120/240 Volts c.a., 30 Ampères Volts c.a., 20 Ampères Prise de Courant DoubleCapacité NE PAS Surchargez GénérateurGestion de la Consommation ExempleSpécifications Recommandations Générales D’ENTRETIENEntretien du Moteur Entretien du GénérateurRemisage du Générateur RemisageRemisage du Moteur Autres Idées de RemisageDépannage Remarques Garantie Limitée Descripción DEL Equipo Tabla DE ContenidosReglas DE Seguridad AdvertenciaCuando Ponga EN Funcionamiento EL Equipo Cuando Añada Combustible O Vacíe EL DepósitoCuando Opere EL Equipo Cuando Transporte O Repare EL EquipoPrecaución Cuando Ajuste O Haga Reparaciones a SU GeneradorCuando Pruebe LA Bujía DEL Motor Conozca SU Generador Tomacorriente Dobles de 120 Voltios AC, 20 AmpTomacorriente con Dispositivo de Seguridad de Antes DE Darle Arranque AL Motor MontajePara Retirar El Generador De La Caja Conecte el ManubrioAgregue Combustible Depósito de combustibleCuando Añada Combustible Asegúrese de girar a tope el pomo de ventilación hacia la Depósito de combustibleTierra del Sistema USO DEL GeneradorConexión al Sistema Eléctrico de un Edificio Ubicación del GeneradorEncienda el Motor Operando EL GeneradorConexion De Cargas Electricas No Sobrecargue EL GENERADOR.Vea No Sobrecargue GeneradorParado Del Motor Receptáculos PrecauciónVolt AC, 20 Amp, Receptáculos Dobles 120/240 Voltios AC, 30 Amp, Receptáculo de SeguridadCapacidad No Sobrecargue GeneradorControl de la Energía EjemploRecomendaciones Generales DE Mantenimiento EspecificacionesMantenimiento del Motor Mantenimiento del GeneradorAlmacenando el Generador AlmacenamientoAlmacenando el Motor Otras Sugerencias Para el AlmacenandoDiagnositicos DE Averías Problemo Accion CausaGarantía Limitada

30253 specifications

Briggs & Stratton 30253 is a powerful and versatile portable generator designed to meet the needs of both homeowners and outdoor enthusiasts. Renowned for its reliability and efficient performance, this generator provides a dependable source of power during emergencies, outdoor events, or for recreational activities.

One of the standout features of the Briggs & Stratton 30253 is its robust engine. Powered by a Briggs & Stratton 800 series engine, it delivers a solid output, ensuring that you have enough energy to run essential appliances and tools. With a running wattage of 3,000 and a starting wattage of 3,500, this generator is capable of powering items such as refrigerators, lights, and power tools simultaneously, making it perfect for home backup during outages or for use on job sites.

The design of the 30253 emphasizes portability and ease of use. It features a compact and lightweight frame, allowing for easy transport and storage. The built-in rugged handle and never-flat wheels provide added mobility, enabling users to maneuver the generator effortlessly across various terrains. This makes it an ideal choice for camping trips, tailgating, or any outdoor project where power is needed.

In terms of technology, the Briggs & Stratton 30253 is equipped with a reliable low-oil shutdown feature, which automatically turns off the engine when oil levels are critically low, safeguarding the generator from potential damage. Additionally, the generator is designed with a durable steel frame and a protective roll cage, enhancing its longevity and performance in tough conditions.

Noise is a common concern with generators, but the 30253 operates at a relatively quiet level, making it more suitable for residential areas or during night use, allowing you to enjoy power without disturbing your neighbors.

Another key characteristic of the Briggs & Stratton 30253 is its user-friendly control panel. The panel includes multiple outlets, including two 120V household outlets and a 12V DC outlet, providing versatility for connecting different devices.

In summary, the Briggs & Stratton 30253 generator combines power, portability, and advanced features, making it an excellent choice for those in need of reliable electricity in various settings. Whether you're preparing for a power outage or setting up for a weekend getaway, this generator is designed to fulfill your energy needs efficiently and effectively.
Top Page Image Contents