How To Order Replacement Parts
The replacement parts are shown either on the back pages of this Instruction Book or in a separate Parts List Book.
Use only manufacturer’s authorized or approved replacement parts. The letter placed on the end of the part number denotes the type of finish for the part, C for chrome, Z for zinc, a PA for purchased assembly. It is important that you include this when ordering a part. Do not use attachments or accessories not specifically
recommended for this unit. In order to obtain proper replacement parts you must supply the model number (see nameplate).
To obtain replacement parts, contact:
BRIGGS AND STRATTON CANADA
Factory Customer Service
1195 Coutneypark Drive East
Mississauga, Ont.
Collect telephone calls will not be accepted. Replacement parts for the engine, transaxle, or
GB
transmission, are available from the manufacturer’s authorized service centre found in the yellow pages of the telephone directory. Also, see the individual engine or transmission warranties to order replacement parts.
When ordering the following information is required:
(1)The Model Number
(2)Serial Number
(3)Part Number
(4)Quantity
TROUBLE SHOOTING CHART
TROUBLE | CAUSE | CORRECTION |
|
|
|
Difficult starting | Defective spark plug. | Replace spark plug. |
|
|
|
| Water or dirt in fuel system. | Use carburetor bowl drain to flush and refill with |
|
| fresh fuel. |
|
|
|
Engine runs erratic | Blocked fuel line, empty gas tank, or stale | Clean fuel line; check fuel supply; add fresh |
| gasoline | gasoline |
|
|
|
Engine stalls | Unit running on CHOKE. | Set choke lever to RUN position. |
|
|
|
Engine runs erratic; | Water or dirt in fuel system. | Use carburetor bowl drain to flush and refill with |
Loss of power |
| fresh fuel. |
|
|
|
Excessive vibration | Loose parts: damaged impeller | Stop engine immediately and disconnect spark |
|
| plug wire. Tighten all bolts and make all |
|
| necessary repairs. If vibration continues, have |
|
| the unit serviced by a competent repairman. |
|
|
|
Unit fails to propel itself | Drive belt loose or damaged. | Replace drive belt. |
|
|
|
| Incorrect adjustment of traction drive cable | Adjust traction drive cable. |
|
|
|
| Worn or damaged friction wheel. | Replace friction wheel. |
|
|
|
Unit fails to discharge snow | Auger drive belt loose or damaged. | Adjust auger drive belt; replace if damaged. |
|
|
|
| Auger control cable not adjusted correctly. | Adjust auger control cable. |
|
|
|
| Shear bolt broken | Replace shear bolt |
|
|
|
| Discharge chute clogged. | Stop engine immediately and disconnect spark |
|
| plug wire. Clean discharge chute and inside of |
|
| auger housing. |
|
|
|
| Foreign object lodged in auger | Stop engine immediately and disconnect spark |
|
| plug wire. Remove object from auger. |
|
|
|
13