Poulan 96194000300 owner manual Training, Preparation, Operation

Page 5

GB

WARNING: This machine is capable ofto amputating hands and feet and throwing objects. Read these safety rules and follow them closely. Failure to obey these rules could result in loss of control of unit, severe personal injury or death to you, or bystanders, or damage to property or equipment. The triangle in text signifies important cau- tions or warnings which must be followed.

Safe Operation Practices for Snowthrowers

IMPORTANT: Safety standards require operator presence controls to minimize the risk of injury. Your snowthrower is equipped with such con- trols. Do not attempt to defeat the function of the operator presence con- trol under any circumstances.

Training

1.Read, understand, and follow all instructions on the machine and in the manuals before operating this unit. Be thoroughly familiar with the con- trols and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly.

2.Never allow children to operate the equipment. Never allow adults to operate the equipment without proper instruction.

3.Keep the area of operation clear of all persons, particularly small children and pets.

4.Exercise caution to avoid slipping or falling especially when operating in reverse.

Preparation

1.Thoroughly inspect the area where the equipment is to be used and remove all doormats, sleds, boards, wires, and other foreign objects.

2.Disengage all clutches and shift into neutral before starting the engine (motor).

3.Do not operate the equipment without wearing adequate winter outer garments. Wear footwear that will improve footing on slippery surfaces. Avoid loose fitting clothing that can get caught in moving parts.

4.Handle fuel with care; it is highly flammable.

a.Use an approved fuel container.

b.Never add fuel to a running engine or hot engine.

c.Fill fuel tank outdoors with extreme care. Never fill fuel tank indoors. Replace fuel cap securely and wipe up spilled fuel.

d.Never fill containers inside a vehicle or on a truck or trailer bed with a plastic liner. Always place containers on the ground, away from your vehicle, before filling.

e.When practical, remove gas--powered equipment from the truck or trailer and refuel it on the ground. If this is not possible, then refuel such on a trailer with a portable container, rather than from a gaso- line dispenser nozzle.

f.Keep nozzle in contact with the rim of the fuel tank or container opening at all times, until refueling is complete. Do not use a nozzle lock--open device.

g.Replace gasoline cap securely and wipe up spilled fuel.

h.If fuel is spilled on clothing, change clothing immediately.

5.Use extension cords and receptacles as specified by the manufactur- er for all units with electric drive motors or electric starting motors.

6.Adjust the collector housing height to clear gravel or crushed rock surfaces.

7.Never attempt to make any adjustments while the engine (motor) is running (except when specifically recommended by manufacturer).

8.Let engine (motor) and snowthrower adjust to outdoor temperatures before starting to clear snow.

9.Always wear safety glasses or eye shields during operation or while performing an adjustment or repair to protect eyes from foreign objects that may be thrown from the machine.

Operation

1.Do not put hands or feet near or under rotating parts. Keep clear of the discharge opening at all times.

2.Exercise extreme caution when operating on or crossing gravel drives, walks or roads. Stay alert for hidden hazards or traffic.

3.After striking a foreign object, stop the engine (motor), remove the wire from the spark plug, disconnect the cord on electric motors, thoroughly inspect snowthrower for any damage, and repair the damage before restarting and operating the snowthrower.

4.If the unit should start to vibrate abnormally, stop the engine (motor) and check immediately for the cause. Vibration is generally a warning of trouble.

5.Stop the engine (motor) whenever you leave the operating position, before unclogging the collector/impeller housing or discharge chute and when making any repairs, adjustments, or inspections.

6.When cleaning, repairing, or inspecting, make certain the collector/im- peller and all moving parts have stopped. Disconnect the spark plug wire and keep the wire away from the spark plug to prevent accidental starting.

7.Do not run the engine indoors, except when starting the engine and for transporting the snowthrower in or out of the building. Open the outside doors; exhaust fumes are dangerous (containing CARBON MONOX- IDE, an ODORLESS and DEADLY GAS).

8.Exercise extreme caution when operating on slopes. Do not attempt to clear steep slopes.

9.Never operate the snowthrower without proper guards, plates, or other safety protective devices in place and working.

10.Never direct the discharge toward people or areas where property damage can occur. Keep children and others away.

11.Do not overload the machine capacity by attempting to clear snow at too fast a rate.

12.Never operate the machine at high transport speeds on slippery sur- faces. Look behind and use care when operating in reverse.

13.Disengage power to the collector/impeller when snowthrower is trans- ported or not in use.

14.Use only attachments and accessories approved by the manufacturer of the snowthrower (such as cabs, tire chains, etc..).

15.Never operate the snowthrower without good visibility or light. Always be sure of your footing and keep a firm hold on the handles. Walk, never run.

16.Never touch a hot engine or muffler.

17.Never operate the snowthrower near glass enclosures, automobiles, window wells, drop--offs, and the like without proper adjustment of the snow discharge angle.

18.Never direct discharge at bystanders or allow anyone in front of the unit.

19.Never leave a running unit unattended. Always disengage the auger and traction controls, stop engine, and remove keys.

20.Do not operate the unit while under the influence of alcohol or drugs.

21.Keep in mind the operator is responsible for accidents occurring to other people or property.

22.Data indicates that operators, age 60 years and above, are involved in a large percentage of power equipment--related injuries. These operators should evaluate their ability to operate the unit safely enough to protect themselves and others from injury.

23.DO NOT wear long scarves or loose clothing that could become entangled in moving parts.

24.Snow can hide obstacles. Make sure to remove all obstacles from the area to be cleared.

5

Image 5
Contents 406888 REV2 02/21/07 Printed U.S.A Manual del usario QuitanievesPage Unit Controls & Equipment Features see FigureEngine Features Operating Symbols and their meanings Hazard Symbols and the meaningsDeath or serious injury Minor or moderate injury From the equipment UseOperation TrainingPreparation Children Service, Maintenance And StorageClearing a Clogged Discharge Chute EmissionsOperation AssemblyHow To Stop Snow Thrower Figure How To Control Discharge Of The SnowHow To Go Forward or Backward Figure How To Throw Snow FigureSnow Throwing Tips Maintenance ChartHow To Remove Snow or Debris From The Auger Housing Maintenance How To Adjust The Belt Guide How To Adjust The BeltsHow To Replace The Belts How To Prepare The Snow Thrower For Storage How To Adjust Or Replace The Friction WheelHow To Replace the Auger Shear Bolt How To Order Replacement Parts Trouble Shooting ChartNone Elite All other Seriest ModelsYears Características del motor Información GeneralEléctrico AdvertenciaDel equipo Fuego Explosión Barrena Embrague de Agarres TransmisiónCapacitación Reglas Para Operación SeguraPreparación OperaciónCómo limpiar una manga de descarga tapada NiñosReparación, mantenimiento y almacenaje EmisionesEnsamblaje Operación Retire la llave de seguridad Sugerencias para el lanzamiento de nieveSuelte la palanca del propulsor de la ba- rrena Mantenimiento Tabla DE MantenimientoCómo ajustar la altura de los patines Figura Partes que no se deben lubricar FiguraCómo ajustar la barra raspadora Figura Cómo revisar y ajustar los cablesCómo ajustar o reemplazar la rueda de fricción Cómo reemplazar las correasCómo ajustar la guía de la correa Cómo preparar el quitanieves para guardarlo Cómo reemplazar los pernos de seguridad de la barrenaCómo hacer un pedido de piezas de repuesto Tabla DE Localización Y Reparación DE AveríasElitet Modelos SeriesAños NingunoAcerca DE LA Garantía DE SU Equipo Page Page Page 2322 Page Page 9524 3943 73826 Parts List Model Liste de pièces Modèle Model no Description Drive 201 198588 CHAIN, Roller #420x19.00 203 198591 200 198600X008204 198592 206 198584 SCREW, TAP 5/16--18x0.5 207 405541244 405562 243 405558245 405561 246 405563Auger Housing 510 405778X479 485 1501158 Washer .343 X 490 188909521 405643X417 522 198636 SCREW, 1/4--20 X 523 198638Handle Key No. Part No Description Chute ROD 198861 198853198862 400192Discharge Chute 584 751153 NUT, 5/16--18 Nylock 596 198662 582 198661597 198851 599 198539 BOLT, 5/16--18 X 600 198842Engine Key Description 621 406471 620 405589622 406470 625 66426673 198669 671 400025675 404517X417 680 404516X417Gear Case