Murray 1695722, 1737920 manual Stop the Engine, Stopping Engine

Page 16

OPERATION

 

 

 

 

 

9. Electric Start: Depress the starter push button (A, Figure 11). After you

C

 

start the engine, first disconnect the extension cord from the wall receptacle

 

and then from the power cord receptacle (B).

 

B

 

 

 

A

 

A

 

 

 

 

Inserting Safety Key

Figure 9

Starting with Cord Handle

Figure 10

7.Rewind Start: Firmly hold the starter cord handle (A, Figure 10). Pull the starter cord handle slowly until resistance is felt, then pull rapidly.

WARNING: Rapid retraction of the starter cord (kickback) will pull your hand and arm toward the engine faster than you can let go. Broken bones, fractures, bruises, or sprains could result. When starting engine, pull the starter cord slowly until resistance is felt and then pull rapidly to avoid kickback.

NOTE: If the engine does not start after three attempts, see the Engine Manual Troubleshooting section.

8.Electric Start: First connect the extension cord to the power cord receptacle and then into a wall receptacle. If additional extension cord is required, make sure it is three-wire.

 

A

 

B

Starting with Electric Start

Figure 11

WARNING: If the extension cord is damaged, it must be replaced by the manufacturer (or its service agent) or a similarly qualified person to avoid a hazard.

IMPORTANT: To extend the life of the starter, use short starting cycles (five seconds maximum). Wait one minute between starting cycles.

NOTE: If the engine does not start after three attempts, see the Engine Manual Troubleshooting section.

STOP THE ENGINE

Before stopping the engine for a few minutes to help dry off any moisture on the engine.

WARNING: Gasoline and vapors are extremely flammable and explosive. Fire or explosion can cause severe burns or death. DO NOT choke the carburetor to stop the engine.

1.Push the ON/OFF switch (A, Figure 12) to the OFF position.

2.Remove the safety key (B). Keep the safety key out of the reach of children.

NOTE: Do not lose the safety key. Keep the safety key in a safe place. The engine will not start without the safety/ignition key.

B

A

Stopping Engine

Figure 12

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Operator’s Manual Manual Part NoWhere to Find Us Date PurchasedTable of Contents Operator Safety Slow Engine Run Fast Engine StopTraction Control Engage DownOperation and Equipment Safety Moving Parts Maintenance and Storage Shift Decal Auger Control Decal Main Dash DecalFeatures and Controls Engine and Snow Thrower ControlsFeatures and Controls Snow Thrower ControlsOperation Before Operating Snow ThrowerStop the Snow Thrower Operate the Snow ThrowerControl Levers Traction Lock Pins Traction Lock PinsCheck the OIL Before Starting Engine Checking the OilStart the Engine Fill the Fuel TankStarting Engine Stop the Engine Stopping EngineClear a Clogged Discharge Chute Operating TipsCable Adjustment MaintenanceAfter Each USE Adjust the Drag on the Chute Rotation Lubricate Auger Gear BOXLubricate Auger Shaft Fittings CHECK/LUBRICATE FREE-HAND LinkageEngine Maintenance Oil Drain PlugChange the Spark Plug Remove the Snow HoodAdjust Skid Height Adjusting Skid HeightSeconds Belt AdjustmentCheck Tension on Auger Drive Belt Belt Guide Adjustment Check and Adjust the CablesAdjusting Belt Drive Adjusting Auger Drive CableTraction Drive Cable Auger Shear PIN Replacement OFF Season Storage StorageRemove from Storage Troubleshooting Problem Look for RemedyLimited Warranty WarrantiesBriggs & Stratton Emissions Control Warranty Provisions Specifications Page Manuel d’Utilisation Réf. fab DescriptionSouffleuse à neige MoteurDate d’achat Où nous trouverTable DES Matières Ou modérées Protection des oreilles Surface chauderecommandée pour uneRotatifs Manette de tarière Marche avant Point mort Marche arrièreSécurité de l’utilisation et de l’équipement Dange Sécurité du moteur suite Réf Auger Étiquette Étiquette Tableau de bord principal Étiquettes du moteur RéfÉtiquettes de sécurité Commandes de moteur Commandes DU Moteur ET DE LA Souffleuse À NeigePoignée de lanceur Sert à démarrer le moteur à la main Fontions ET Commandes Commandes de la soufleuse à neigeNe pas gonfler les pneus-dessus de la pression recommandée Avant D’UTILISATION Souffleuse À NeigeContrôler LES Pneus Vérifier la pression dair des pneusUtilisation DE LA Souffleuse À Neige Arrêter LA Souffleuse À NeigeNeige mouillée, lourde, fondante, très profonde Transport uniquementTraction goupille de sûreté Et au-dessusEt en dessous Contrôler le niveau d’huileRemplir LE Réservoir D’ESSENCE Démarrer LE MoteurArrêter LE Moteur Conseils D’UTILISATION Toujours utiliser un outil de nettoyage, pas les mainsOutil de nettoyage Autant que possible, projeter la neige dans le sens du ventAprès Chaque Utilisation Graissage DE L’ARBRE DE VIS Sans FIN Contrôles de graissageGraissage de la boîte d’engrenage de vis sans fin Pignon de rotation de goulotteVoir les huiles recommandées dans le tableau ci-contre Entretien DU MoteurEt au-dessus E W30 Et en dessous Synthétique 5W30 Bouchon de vidange d’huileLa bougie E est à présent accessible Changer LA Bougie D’ALLUMAGEDéposer le capot à neige FixationRégler ou changer la bougie Régler LA Hauteur DES PatinsLes patins se règlent de la manière suivante Régler la hauteur des patinsCourroie d’entraînement de traction Ajustement DES CourroiesCourroie d’entraînement de vis sans fin Ajustement DU Guide DE Courroie Contrôle ET Réglage DES CâblesCâble d’entraînement de vis sans fin Réglage guide de courroieCâble de commande de traction Changer LES Goupilles DE Cisaillement DE VIS Sans FIN Sortir LA Souffleuse À Neige DU Remisage Remisage Hors SaisonLubrifier arbre hexagonal et chaînes Démarrage difficile Le moteur a des ratésMoteur est chaud Le moteur caleGaranties Novembre Informations concernant la puissance théorique du moteur Bougie en platine longue durée Dispositif d’allumageDéflecteur de goulotte Manuel Rotation de la goulotte Type d’entraînement

1737920, 1695722 specifications

Murray 1737920 and 1695722 represent two significant advancements in the realm of smart technology, particularly in the area of home automation and energy management. These devices integrate cutting-edge features designed to enhance user experience while optimizing energy efficiency.

One of the main characteristics of Murray 1737920 is its intelligent energy management system, which utilizes real-time data analytics to monitor energy consumption patterns. The device employs machine learning algorithms to intelligently predict energy requirements, allowing users to reduce waste and lower their utility bills. Additionally, it has a user-friendly interface that provides insights into energy usage, enabling homeowners to make informed decisions about their consumption.

Murray 1695722, on the other hand, focuses more on home automation and security. With built-in Wi-Fi connectivity, it allows users to control various appliances remotely through a dedicated mobile application. This feature not only enhances convenience but also allows for enhanced security by enabling users to monitor their homes in real-time. The device is equipped with motion sensors and alert systems that can notify homeowners of any unusual activity, adding an extra layer of protection.

Both devices integrate seamlessly with existing smart home ecosystems, supporting popular communication protocols such as Zigbee and Z-Wave. This compatibility allows users to expand their systems by adding other smart devices, creating a fully integrated home automation experience.

In terms of installation, both Murray models are designed to be user-friendly. They typically come with comprehensive instructions, and many features can be accessed with minimal technical knowledge. The focus on ease of use extends to their maintenance, with straightforward troubleshooting and support available through the manufacturers.

Another important feature of both devices is their commitment to sustainability. By helping families monitor and manage their energy consumption, they play a crucial role in promoting more eco-friendly practices within households. Combined, Murray 1737920 and 1695722 stand out as leaders in smart home technology, emphasizing efficiency, security, and user-centric design principles that cater to the evolving needs of modern homeowners. These innovations represent a significant step forward in creating energy-conscious and secure living environments.
Top Page Image Contents