Craftsman 536.88112 operating instructions Not

. Remove and discard all packing material from around the snow thrower.

. For shipping purposes, the height adjust skids are attached to the pallet. Remove the screw that se- cures each height adjust skid to the pallet. See Figure 3.

8.Cut the ties that secure the clutch control cables to the lower handle. See Figure 1. Move the cables away from the motor frame.

9.Make sure the clutch control cables are attached to the clutch

levers. See Figure 4.

10.Tighten the bolts that secure the upper and lower handles.

Hei(	Clutch Lever
Adjust
Skid

Screw Figure 3

. Loosen (,do not remove) the bolts that fasten the upper and lower handles. Raise the upper handle into the operating position.

NOTE: Make sure the cables are

not caught between the upper and lower handles.

\

Clutch Control Cable Figure 4

11.Hold onto the handle and pull the snow thrower off the carton.

CAUTION: DO NOT back over

cables.

How To

Assemble

.

Install the screw,

flatwasher, lock-

The

Handle

And

Crank

Assembly

washer,

and

hex

nut into the bot-

1.

Loosen,

but do

not remove, the fas-

tom hole

on the right side of the

teners

in the upper holes of the

handles.

DO

NOT

tighten until all

lower handle. See Figure 5.

fasteners

are

in place.

Upper

Handle

/

Loosen, Do'_

Not

Remove

I

P

r

/

Loosen, Do

Crank

_l_

Lower

Handle

,,_

_,#

Not Remove

Flatwasher 3/8"

Assembly

Locknut

Nut 3/8

-_j

Screw 3/8" x 2'

Eyebolt

Flatwasher

,_

Lockwasher 318"/

Flatwasher 3/8"

Figure 5

F-001129J8