Connecting to a Computer
When connecting a computer, ensure that it is the last device to be turned on after all the connections are made.
Connecting to a computer (INPUT 5)
•Before connecting the cable, switch the digital input type switch to “PC”.
Computer
1
Switch to “PC”
| INPUT 5 terminal |
RGB output terminal |
|
| 2 |
RGB cable (commercially available) |
|
4 |
|
3 | DVI to |
| (commercially available) |
Note
•Refer to “Computer Compatibility Chart” on page 61 for a list of computer signals compatible with the projector. Use with computer signals other than those listed may cause some of the functions not to work.
•When connecting the projector to a computer in this way, select “RGB” for “Signal Type” on the OSD menu or press
on the remote control. (See page 48.)
•A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest EIKI Autho- rized Dealer or Service Center.
•Depending on the computer you are using, an image may not be projected unless the signal output setting of the computer is switched to the external output. Refer to the owner’s manual of the computer for switching the computer signal output settings.
25