Eiki LC-SD10 Remote Control Battery Installation, Attaching the Lens Cover, Remove the battery

Preparation

Remote Control Battery Installation

1	Remove the battery
	compartment lid.

Pull up and remove the lid.

2	Slide the batteries into	3	Replace the compartment
	the compartment.		lid.

Two AAA size batteries For correct polarity (+ and

–), be sure battery terminals are in contact with pins in compartment.

To insure safe operation, please observe the following precautions :

–Use (2) AAA, SUM-4 or R03 type alkaline batteries.

–Replace two batteries at the same time.

–Do not use a new battery with a used battery.

–Avoid contact with water or liquid.

–Do not expose the remote control to moisture, or heat.

–Do not drop the remote control.

–If a battery has leaked on remote control, carefully wipe case clean and install new batteries.

–Risk of explosion if battery is replaced by an incorrect type.

–Dispose of used batteries according to the instructions.

Attaching the Lens Cover

Thread the string through the hole on the lens

1 cover and then tie a knot in the string to secure it in place.

Thread the other end of the string through the

2 hole at the bottom of the projector. Then pass the lens cover through the resulting loop of the string. Tie a knot in the string to secure it in place.

14