Eiki LC-XBM31 owner manual Standby mode, Count down 00000-18000, At Restart to resume Count up or

Setting

Standby mode

This function is available when operating the projector via network.

Network..... Supply the power to the network function

even after turning off the projector by pressing the ON/STAND-BY button on the remote control. You can turn on/off the projector via network, modify network environment, and receive an e-mail about projector status while the projector is powered off.

Eco............. Select Eco when you do not use the

projector via network. The projector’s network function will stop when turning off the projector, you can not turn on the projector via network.

Refer to the owner’s manual of “Network Set-up and Operation”.

Note:

•When selecting Network, the cooling fans may be running depending on the temperature inside the projector even if the projector is turned off.

•When Eco mode is selected and the projector is in Stand-by, the communication of RS- 232C serial port is not available.

P-timer

This function allows you to change the setting of the P- timer and execute it.

Select one of the following options:

Count up	The P-timer display 000:00 appears
	on the screen and the count starts
Count down	(000:00–180:00)
	The time set in the Timer setting
	appears on the screen and the
Timer	countdown starts.
	Use the Point ▲▼ buttons to set the
	Timer (1–180 Min). Timer is available
	in Count down only. Factory default
Start	velue is 10 Min.
	It executes the count up or count
	down function. Press the SELECT
	button at Start and the indication
	changes into Stop. To stop Count
	up or Count down, press the
	SELECT button at Stop on the screen
	menu,then the indication changes into
	Restart. Press the SELECT button
	at Restart to resume Count up or
Reset	Count down.
	Reset the P-timer values.
	Press the SELECT button at Reset to
	return to the following value;
	Count up ... "000:00"
Exit	Count down ... Timer that you set
	To exit the P-timer operation.

X: disabled	O: enabled
Serial command
Network
Monitor Out
Audio Out		*1
Direct on

*1 When switch the Standby MIC out function On and in Standby mode status, only MIC volume can be output.

P-TIMER

0

P-timer display

Stop or Cancel the P-timer via Remote Control

To stop the P-timer function, press the P-TIMER button. To cancel the P-timer, press and hold the P-TIMER button for a few seconds.

50