Setting
Fan
This function provides the following options in the cooling fans’ operation when the projector is turned off (p.20).
L 1...... Normal operation
L 2...... Slower,
normal operation (L 1).
Fan control
Choose the running speed of cooling fans from the following options according to the ground elevation under which you use the projector.
Off................ Normal speed. Set this function to
Off when using the projector in non- high altitude environment.
On 1............. Faster than Off mode. Select this
mode when using the projector in high altitudes (about 1,000 meters to 2,000 meters above the sea level) where the fans have less cooling effect.
On 2............. Faster than On 1 mode. Select this
| mode when using the projector in |
| higher altitudes (about 2,000 meters |
| to 3,000 meters above the sea level) |
| where the fans have lesser cooling |
| effect. |
Note: | Lamp counter reset |
The fan noise becomes louder in On 1 and
On 2.
Video delay control
When you want to make a digital processing of a projected image faster, set this function.
Use the Point ▲▼ buttons, select an item of Off or
On.
Note:
Noise reduction and Progressive can not be selected when Video delay control function is set to On.
Lamp counter
Be sure to reset the Lamp replacement counter after the lamp is replaced. (p. 62)
Press the Point ▲▼ buttons to choose the Lamp counter function and then press the Point ► or the SELECT button to access the submenu items. Lamp counter................This item shows the total
accumulated time of the lamp usage.
Lamp counter reset.......Press the SELECT button to
choose Lamp counter reset.. Select Yes in the confirmation box if you want to reset the lamp counter, and then choose Yes in the second confirmation box to reset lamp counter.
55