Maintenance and Cleaning
Replacing the Filter
Filter prevents dust from accumulating on the optical elements inside the projector. Should the Filter become clogged with dust particles, it will reduce cooling fans’ effectiveness and may result in internal heat buildup and adversely affect the life of the projector. If a “Filter warning” icon appears on the screen, replace the Filter immediately. Replace the filter by following the steps below.
1Turn off the projector, and unplug the AC power cord from the AC outlet.
2Put you finger on the latch’s mark, pull it the unlock position and remove.
3Put the new one back into the position.
Put you finger on the latch’s mark, pull it the lock position to lock.
4Connect the AC power cord to the projector and turn on the projector.
5Reset the filter counter.
CAUTION
- Do not operate the projector with the filters removed. Dust may accumulate on the optical elements degrading picture quality.
-Do not put anything into the air vents. Doing so may result in malfunction of the projector.
-Do not wash the filter with water or any other liquid Matter. Otherwise the filter may be damaged.
RECOMMENDATION
We recommend avoiding dusty/smoky environments when you operate the projector. Usage in these environments may cause poor image quality.
When using the projector under dusty or smoky conditions, dust may accumulate on a lens, LCD panels, or optical elements inside the projector degrading the quality of a projected image. When the symptoms above are noticed, contact your authorized dealer or service center for proper cleaning.
Resetting the Filter Counter
Be sure to reset the Filter counter after cleaning or replacing the filters.
1Press the MENU button to display the On-
Screen Menu. Use the Point ▲▼ buttons to select Setting and then press the Point ► or the
SELECT button.
2Use the Point ▲▼ buttons to select Filter counter and then press the Point ► or the SELECT button. Use the Point ▲▼buttons to select Filter counter reset and then press the SELECT button. Filter counter Reset? appears. Select Yes to continue.
3Another confirmation dialog box appears, select Yes to reset the Filter counter.
Filter Latch
Lock | Note: |
| |
| • When replacing the filter, |
| it is required a certain |
| space to pull out the filter |
Unlock | completely. |
• When installing the | |
| projector, install the |
| projector with keeping a |
| certain space for replacing |
| the filter. |
Filter counter reset
Filter counter
Reset? appears.
Select Yes, then another confirmation box appears.
Select Yes again to reset the Filter counter.
59