Intel MGM45WU manual Processor, System Memory

Mobile Board Features

Processor

Intel Mobile Board MGM45WU supports the following Intel® processors in the mPGA479 package:

•Intel Core 2 Duo mobile processors with a 1066/800 FSB

•Intel Celeron mobile processors with a 667 FSB

Processors are not included with the Mobile Board and must be purchased separately. For instructions on installing a processor, go to page 37 in Chapter 2.

System Memory

NOTE

To be fully compliant with all applicable Intel® SDRAM memory specifications, the board should be populated with DIMMs that support the Serial Presence Detect (SPD) data structure. If your memory modules do not support SPD, you will see a notification to this effect on the screen at power up. The BIOS will attempt to configure the memory controller for normal operation.

The Mobile Board supports the dual or single channel memory configurations defined below.

•Two 200-pin Double Data Rate 2 (DDR2) Small Outline Dual Inline Memory Module (SO-DIMM) sockets with gold-plated contacts

•Support for:

⎯Non-ECC DDR2 800/667 memory

⎯Serial Presence Detect (SPD) memory only

⎯Unbuffered, non-registered single- or double-sided DIMMs

⎯Memory configurations listed below:

•Up to 2.0 GB utilizing 256 Mb technology

•Up to 4.0 GB utilizing 512 Mb or 1 Gb technology

For instructions on installing memory, refer to “Installing System Memory” on page 56 in Chapter 2.

17