Technical Reference
Table 28 describes the two configurations of this connector/jumper block.
CAUTION
Do not place jumpers on this block in any configuration other than the one described in Table 28. Other jumper configurations are not supported and could damage the Desktop Board.
Table 28. Front Panel Audio Connector/Jumper Block
Jumper Setting
1 | 2 |
3 | 4 |
5 | 6 |
7 |
|
9 | 10 |
1 | 2 |
3 | 4 |
5 | 6 |
7 |
|
9 | 10 |
1 and 2
3 and 4
5 and 6
9 and 10
No jumpers installed
Configuration
Audio line out signals are routed to the back panel audio line out connector. The back panel audio line out connector is shown in Figure 8 on page 44.
Audio line out and mic in signals are available for front panel audio connectors. Table 17 on page 47 lists the names of the signals available on this connector when no jumpers are installed.
#INTEGRATOR’S NOTE
When the jumpers are removed and this connector is used for front panel audio, the back panel audio line out and mic in connectors are disabled.
2.9.2BIOS Setup Configuration Jumper Block
The
Table 29. BIOS Setup Configuration Jumper Settings
Function/Mode
Normal
Configure
Recovery
Jumper Setting
1 | 3 | |
|
| |
1 | 3 | |
|
| |
None | 1 | 3 |
|
|
Configuration
The BIOS uses current configuration information and passwords for booting.
After the POST runs, Setup runs automatically. The maintenance menu is displayed.
The BIOS attempts to recover the BIOS configuration. A recovery diskette is required.
57