|
| Networking Silicon — 82540EP | |
|
|
| |
Symbol | Type | Name and Function | |
|
|
| |
FL_CE# | O | FLASH Chip Enable Output. Used to enable FLASH device. | |
|
|
| |
FL_SCK | O | FLASH Serial Clock Output. The clock rate of the serial FLASH interface is | |
approximately 1 MHz. | |||
|
| ||
|
|
| |
FL_SI | O | FLASH Serial Data Input. This pin is an output to the memory device. | |
|
|
| |
FL_SO | I | FLASH Serial Data Output. This pin is an input from the FLASH memory. It has an | |
internal pullup device. | |||
|
| ||
|
|
|
3.4Miscellaneous Signals
3.4.1LED Signals
Symbol | Type | Name and Function | |
|
|
| |
LED0 / LINK# | O | LED0 / LINK Up. Programmable LED indication. Defaults to indicate link | |
connectivity. | |||
|
| ||
|
|
| |
LED1 / ACT# | O | LED1 / Activity. Programmable LED indication. Defaults to flash to indicate | |
transmit or receive activity. | |||
|
| ||
|
|
| |
LED2 / LINK100# | O | LED2 / LINK 100. Programmable LED indication. Defaults to indicate link at | |
100 Mbps. | |||
|
| ||
|
|
| |
LED3 / LINK1000# | O | LED3 / LINK 1000. Programmable LED indication. Defaults to indicate link at | |
1000 Mbps. | |||
|
| ||
|
|
|
3.4.2Other Signals
Symbol | Type | Name and Function | |
|
|
| |
|
| Software Defined Pin. The Software Defined Pins are reserved and programmable | |
SDP[7:6] |
| with respect to input and output capability. These default to input signals upon | |
TS | but may be configured differently by the EEPROM. The upper four bits may be mapped | ||
SDP[1:0] | |||
| to the General Purpose Interrupt bits if they are configured as input signals. | ||
|
| ||
|
| Note: SDP5 is not included in the group of Software Defined Pins. | |
|
|
|
Datasheet | 13 |