Nikon LS-2000 manual Connect the power cable, Safety Precautions

Page 18

3. Setup

Step 3—Connect the power cable

Before connecting the power cable, confirm that the scanner is off and that the transport locking screws have been removed from the side of the scanner and adapter slot. The scanner is off when the end of the power switch marked “0” is down.

Power switch off

Attach the female end of the power cable to the AC connector on the rear of the scanner and insert the male end into a general- purpose household outlet.

Safety Precautions

•Use an AC power supply of 50/60Hz and a voltage of from 100V–240V. Be sure to use a power cord rated for the appropri- ate voltage.

At voltages of more than AC 125V:

use a power cord that complies with the safety standards of the country in which it is used, which has a plug rated for AC 250V, 15A (NEMA 6P-15) and insulation of SVT type or better, and which is more than AWG18 in thickness.

At voltages of AC 125V or less:

use a power cord that complies with the safety standards of the country in which it is used, which has a plug rated for AC 125V, 10A and insulation of SVT type or better, and which is more than AWG18 in thickness.

•Do not damage or modify the power cable. Fire or electric shock may result if the cable is placed under heavy objects, exposed to heat or flame, or forcibly tugged or bent.

8

Nikon LS-2000 35 mm Film Scanner User’s Guide

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Page Page LS-2000 Users GuideSymbol Trademark InformationIii Do not disassemble Safety PrecautionsKeep clean Do not modifyWhen not using for an extended period When performing routine maintenanceDo not place foreign objects inside the scanner When transporting the scanner Vii Contents Overview Overview Parts and Accessories What’s in the BoxParts of the LS-2000 Setup Setting up the LS-2000Choose a location for the scanner When installing the scanner on its base Setup Connect the power cable Safety PrecautionsDo not connect or disconnect the cable while the power is on Connect the Scsi cable When the scanner is the last device in the chain When the scanner is between other devices Scsi connection checklist Set the scanner’s Scsi ID 0 0 9 8MADE in Japanscsi NB Terminator OFF Software Installation Review the system requirementsMacintosh Install Adobe Acrobat Reader WindowsInstall Nikon Scan From disk provided by hardware Setup Scanning Turn on your computerStart Nikon Scan Insert an adapter in the scanner Inserting the SA-20 Strip Film Insert film Choose a film type Choose a color spaceChoose a thumbnail SA-20 Perform a preview scanAuto contrast adjustment Select a cropAdjust color balance, contrast, and brightness Remove dust and scratchesScan the selected crop Scan additional imagesScanning Appendix Nikon Scan Controls Menus, Tabs, and Information DisplaysButtons Control Drawers Scan-Size DrawerScanner Extras Drawer Curves-and-Levels Drawer Color-Balance DrawerPreferences Color managementEC Declaration of Conformity Declaración DE Conformidad DE LA CEE
Top Page Image Contents