Nikon LS-2000 manual Set the scanner’s Scsi ID

Page 24

3. Setup

Step 5—Set the scanner’s SCSI ID

Each device in the SCSI chain has a unique ID, which is a number between zero and seven that the computer uses to distinguish between different devices. When connecting the LS-2000 to a SCSI chain, the scanner’s SCSI ID must be set to a number that is not shared by any of the other devices, including the computer itself.

The scanner’s SCSI ID is indicated by the SCSI ID dial on the rear panel. Before the scanner leaves the factory, the ID is set to “2.”

SCSI ID

3 2

1

4

0

5

6 7

When choosing another ID for the scanner, bear in mind that the computer will usually have an ID of either “0” or “7,” and that internal hard disks often have IDs of “0” or “1.” In the case of Macintosh computers, the computer will have an ID of “7,” while the internal hard disk and CD-ROM drive often have IDs of “0” and “3,” respectively. In general, it is recommended that you set the scanner’s ID to any number other than zero, one, three, and seven that is not used by another SCSI device.

✔Caution: Assigning the same ID to two different devices could render the computer system inoperable or result in important data on a hard disk being lost or corrupted.

14	Nikon LS-2000 35 mm Film Scanner User’s Guide

Image 24

Contents Page Page LS-2000 Users GuideSymbol Trademark InformationIii Safety Precautions Keep cleanDo not disassemble Do not modifyWhen not using for an extended period When performing routine maintenanceDo not place foreign objects inside the scanner When transporting the scanner Vii Contents Overview Overview Parts and Accessories What’s in the BoxParts of the LS-2000 Setup Setting up the LS-2000Choose a location for the scanner When installing the scanner on its base Setup Connect the power cable Safety PrecautionsDo not connect or disconnect the cable while the power is on Connect the Scsi cable When the scanner is the last device in the chain When the scanner is between other devices Scsi connection checklist Set the scanner’s Scsi ID 0 0 9 8MADE in Japanscsi NB Terminator OFF Software Installation Review the system requirementsMacintosh Install Adobe Acrobat Reader WindowsInstall Nikon Scan From disk provided by hardware Setup Scanning Turn on your computerStart Nikon Scan Insert an adapter in the scanner Inserting the SA-20 Strip Film Insert film Choose a film type Choose a color spaceChoose a thumbnail SA-20 Perform a preview scanAuto contrast adjustment Select a cropAdjust color balance, contrast, and brightness Remove dust and scratchesScan the selected crop Scan additional imagesScanning Appendix Nikon Scan Controls Menus, Tabs, and Information DisplaysButtons Control Drawers Scan-Size DrawerScanner Extras Drawer Curves-and-Levels Drawer Color-Balance DrawerPreferences Color managementEC Declaration of Conformity Declaración DE Conformidad DE LA CEE