Nikon manual Setup, Setting up the LS-2000, Choose a location for the scanner

Page 15

3. Setup

3. Setup

This chapter takes you step-by-step through the process of setting up the LS-2000 and installing Nikon Scan.

3.1Setting up the LS-2000

This section outlines the steps involved in connecting the LS-2000 to a computer. Before using your scanner, you will need to com- plete the following steps:

•select a suitable location for the scanner

•remove the transport locking screws

•connect the power and SCSI cables

•set the SCSI ID

Step 1—Choose a location for the scanner

Before connecting the LS-2000 to your computer, choose a flat, stable location for it, free from vibration and dust. Do not install your scanner where:

•it would be exposed to direct or reflected sunlight

•it would be subject to condensation or drastic changes in temperature

•it would be subject

to radio interference from other electronic devices

• the temperature exceeds 35ºC (95ºF) or falls below 10ºC (50ºF)

•other objects would block the scanner’s vents

Nikon LS-2000 35 mm Film Scanner User’s Guide

5

Image 15

Contents Page Page Users Guide LS-2000Trademark Information SymbolIii Do not modify Safety PrecautionsKeep clean Do not disassembleWhen not using for an extended period When performing routine maintenanceDo not place foreign objects inside the scanner When transporting the scanner Vii Contents Overview Overview What’s in the Box Parts and AccessoriesParts of the LS-2000 Setup Setting up the LS-2000Choose a location for the scanner When installing the scanner on its base Setup Safety Precautions Connect the power cableDo not connect or disconnect the cable while the power is on Connect the Scsi cable When the scanner is the last device in the chain When the scanner is between other devices Scsi connection checklist Set the scanner’s Scsi ID 0 0 9 8MADE in Japanscsi NB Terminator OFF Software Installation Review the system requirementsMacintosh Windows Install Adobe Acrobat ReaderInstall Nikon Scan From disk provided by hardware Setup Scanning Turn on your computerStart Nikon Scan Insert an adapter in the scanner Inserting the SA-20 Strip Film Insert film Choose a color space Choose a film typePerform a preview scan Choose a thumbnail SA-20Select a crop Auto contrast adjustmentRemove dust and scratches Adjust color balance, contrast, and brightnessScan additional images Scan the selected cropScanning Menus, Tabs, and Information Displays Appendix Nikon Scan ControlsButtons Control Drawers Scan-Size DrawerScanner Extras Drawer Color-Balance Drawer Curves-and-Levels DrawerColor management PreferencesEC Declaration of Conformity Declaración DE Conformidad DE LA CEE