Nikon LS-2000 manual When the scanner is between other devices

Page 22

3. Setup

When the scanner is between other devices

1. Set the terminator switch on the rear of the scanner to OFF

TERMINATOR

OFF ON

2.Connect the SCSI cable from one of the devices in the chain to either of the connectors on the rear of the scanner, then connect a cable to the remaining connector and attach the other end to a connector on the next device in the chain

100–240V~

0.3–0.2A 50/60 Hz

1 0 0 0 9 8	MADE IN JAPAN	SCSI NB
		4	5
	2		6
		1
	S C S I	0

Other SCSI device

TERMINATOR

OFF ON

S C S I

Terminator

3. Confirm that the last device in the chain is terminated

Note: If the last device in the chain has an unused SCSI connector, a separate terminator should be attached to it, even if the device is connected to the SCSI chain using a through terminator.

12	Nikon LS-2000 35 mm Film Scanner User’s Guide

Image 22

Contents Page Page LS-2000 Users GuideSymbol Trademark InformationIii Do not disassemble Safety PrecautionsKeep clean Do not modifyWhen performing routine maintenance When not using for an extended periodDo not place foreign objects inside the scanner When transporting the scanner Vii Contents Overview Overview Parts and Accessories What’s in the BoxParts of the LS-2000 Setting up the LS-2000 SetupChoose a location for the scanner When installing the scanner on its base Setup Connect the power cable Safety PrecautionsDo not connect or disconnect the cable while the power is on Connect the Scsi cable When the scanner is the last device in the chain When the scanner is between other devices Scsi connection checklist Set the scanner’s Scsi ID 0 0 9 8MADE in Japanscsi NB Terminator OFF Review the system requirements Software InstallationMacintosh Install Adobe Acrobat Reader WindowsInstall Nikon Scan From disk provided by hardware Setup Turn on your computer ScanningStart Nikon Scan Insert an adapter in the scanner Inserting the SA-20 Strip Film Insert film Choose a film type Choose a color spaceChoose a thumbnail SA-20 Perform a preview scanAuto contrast adjustment Select a cropAdjust color balance, contrast, and brightness Remove dust and scratchesScan the selected crop Scan additional imagesScanning Appendix Nikon Scan Controls Menus, Tabs, and Information DisplaysButtons Scan-Size Drawer Control DrawersScanner Extras Drawer Curves-and-Levels Drawer Color-Balance DrawerPreferences Color managementEC Declaration of Conformity Declaración DE Conformidad DE LA CEE