Nikon LS-2000 manual When transporting the scanner

Page 8

When transporting the scanner

The LS-2000 is for use only in the country of sale. Nikon will not be held responsible for consequences resulting from use overseas.

The scanning mechanism must be locked in its home position for transport within the country. To return the scanning mechanism to its home position, remove any adapters from the adapter slot and then turn the scanner on. The status LED will blink while the scanning mechanism returns to the home position. Wait until the status LED glows steadily, then turn off and unplug the scanner. Place the guard in the adapter slot as shown below, sliding it in until it contacts the back of the slot.

Remove the transport locking screws from the rear panel and screw them into the holes provided in the side panel and the mouth of the adapter slot (the hole in the mouth of the slot should align with the hole in the guard). Close the front cover and pack the scanner and adapters in the original packing material for transport.

✔Caution: Do not transport the scanner without first locking the scanning mechanism with the transport lock screws. Moving the scanner without the lock screws in place could damage the mecha- nism.

vi	Nikon LS-2000 35 mm Film Scanner User’s Guide

Image 8

Contents Page Page LS-2000 Users GuideSymbol Trademark InformationIii Safety Precautions Keep cleanDo not disassemble Do not modifyDo not place foreign objects inside the scanner When not using for an extended periodWhen performing routine maintenance When transporting the scanner Vii Contents Overview Overview Parts and Accessories What’s in the BoxParts of the LS-2000 Choose a location for the scanner SetupSetting up the LS-2000 When installing the scanner on its base Setup Connect the power cable Safety PrecautionsDo not connect or disconnect the cable while the power is on Connect the Scsi cable When the scanner is the last device in the chain When the scanner is between other devices Scsi connection checklist Set the scanner’s Scsi ID 0 0 9 8MADE in Japanscsi NB Terminator OFF Macintosh Software InstallationReview the system requirements Install Adobe Acrobat Reader WindowsInstall Nikon Scan From disk provided by hardware Setup Start Nikon Scan ScanningTurn on your computer Insert an adapter in the scanner Inserting the SA-20 Strip Film Insert film Choose a film type Choose a color spaceChoose a thumbnail SA-20 Perform a preview scanAuto contrast adjustment Select a cropAdjust color balance, contrast, and brightness Remove dust and scratchesScan the selected crop Scan additional imagesScanning Appendix Nikon Scan Controls Menus, Tabs, and Information DisplaysButtons Scanner Extras Drawer Control DrawersScan-Size Drawer Curves-and-Levels Drawer Color-Balance DrawerPreferences Color managementEC Declaration of Conformity Declaración DE Conformidad DE LA CEE