Solving computer problems
Solution:
Check whether any option has been selected that would disable your computer from entering standby or hibernation mode.
Problem:
The system does not wake up at the time set on the timer, if the computer is not connected to an ac power source,
The system does not enter hibernation mode from suspend mode if the computer is not connected to an ac power source.
Solution:
The
With this risk in mind, you can enable the
1.Turn your computer off and then on again; then, while the message, “To interrupt normal startup, press the blue Access IBM button” is displayed at the lower left of the screen, press the Access IBM button. Rescue and Recovery screen opens.
2.Click Access BIOS. The System Restart Required window is displayed.
3.Click Yes. The computer restarts, and the BIOS Setup Utility menu appears.
4.With the cursor key, select Config; then press Enter. The Power submenu is displayed.
5.Select Timer Wake with Battery Operation by pressing Enter.
6.With the F5 or F6 key, select Enabled; then press Enter.
7.Press F10 and Enter to save this setting and exit this utility.
For information about the BIOS Setup Utility, see “BIOS Setup Utility” in Access IBM, your
Problem:
The Fn+F12 key combination does not make the computer enter hibernation mode.
Solution:
The computer cannot enter hibernation mode:
vIf you are using one of the communication PC Cards. To enter hibernation mode, stop the communication program, and then remove the PC Card or disable the PC Card slot. Click the Safely Remove Hardware icon in the taskbar (for Windows XP) or the Unplug or Eject Hardware icon in the taskbar (for Windows 2000).
vIf the hibernation mode is not enabled. To enable it, do as follows:
23