Lenovo 1010, 992, 981, 1008 manual Server components

Page 35

To reduce the possibility of damage from electrostatic discharge, observe the following precautions:

Limit your movement. Movement can cause static electricity to build up around you.

The use of a grounding system is recommended. For example, wear an electrostatic-discharge wrist strap, if one is available. Always use an electrostatic-discharge wrist strap or other grounding system when working inside the server with the power on.

Handle the device carefully, holding it by its edges or its frame.

Do not touch solder joints, pins, or exposed circuitry.

Do not leave the device where others can handle and damage it.

While the device is still in its static-protective package, touch it to an unpainted metal part on the outside of the server for at least 2 seconds. This drains static electricity from the package and from your body.

Remove the device from its package and install it directly into the server without setting down the device. If it is necessary to set down the device, put it back into its static-protective package. Do not place the device on the server cover or on a metal surface.

Take additional care when handling devices during cold weather. Heating reduces indoor humidity and increases static electricity.

Server components

The following illustration shows the major components in the server.

1

2

3

4

5

Heat sink

Microprocessor

Memory modules

Optical drive

Front bezel

6

7

8

9

10

Front fan assembly

Hard disk drive

System board

Rear fan assembly

Power supply

Chapter 6. Replacing FRUs 29

Image 35
Contents ThinkServer Hardware Maintenance Manual Page ThinkServer Hardware Maintenance Manual Second Edition December Copyright Lenovo Contents Index About this manual Important Safety InformationTo Connect To Disconnect Safety statementsAbout this manual ≥ 18 kg 39.7 lb ≥ 32 kg 70.5 lb Important information about replacing RoHS compliant FRUs ThinkServerHardware Maintenance Manual General information Features and specificationsSecurity features Power supplySystem management features Input/Output I/O featuresEasyManage SoftwareEasyStartup ThinkServerHardware Maintenance Manual General Checkout Problem determination tipsThinkServerHardware Maintenance Manual Navigating through the diagnostics programs DiagnosticsPC-Doctor for DOS Creating a diagnostic disc Running the diagnostic program from a diagnostic discTest results Running testsViewing the test log Troubleshooting tablesHard disk drive boot error Beep Symptom FRU/Action Power Supply ProblemsBeep symptoms Error FRU/ActionPost Error Message Description/Action Post error codesLong and 9 short beeps Bios ROM error Continuos long beeps Dram memory errorHard Disk Install Failure EasyStartup problemsDisplay/Monitor Miscellaneous error messagesMessage/Symptom FRU/Action Second device hard disk First device networkUndetermined problems ThinkServerHardware Maintenance Manual Rear view Locating Server Controls and connectorsFront view Connector Description System board connector locations System-board internal connectorsComponent locations Internal componentsInspecting for unsafe conditions Guidelines for trained service techniciansReplacing FRUs Handling static-sensitive devices Guidelines for servicing electrical equipmentServer components Removing the server cover Replacing FRUsRemoving the server cover Removing and reinstalling the front bezelRemoving the front bezel Installing or replacing a PCI cardOpening the PCI card latch Removing a PCI card Installing a PCI card Replacing the batteryRemoving the old battery Installing or replacing a memory moduleOpening the retaining clips Installing a memory module Installing or replacing the optical driveRemoving the optical drive Replacing the secondary hard disk drive Installing a secondary hard disk driveRemoving the secondary hard disk drive cage Installing the secondary hard disk drive Removing the screws for the power supply assembly Replacing the power supply assemblyReplacing the heat sink and fan assembly Replacing the microprocessor Removing the heat sink and fan assemblyThinkServerHardware Maintenance Manual Removing the microprocessor Replacing the system boardRemoving the system board Installing the socket cover Removing the primary hard disk drive Replacing the primary hard disk driveInstalling the hard disk drive into the bracket Installing the primary hard disk drive Replacing the front fan assembly Removing the front fan assembly Installing the front fan assembly Replacing the rear fan assemblyRemoving the rear fan assembly Installing the rear fan assembly Completing the parts replacementReinstalling the server cover Updating the server configurationFRUs Parts Listing, TS200v Machine Types 0981, 0992, 1008,Machine Type CTO Line Cords FRUs listed in the following tables are not illustratedWindows Server 2008 R2 Foundation 64-bit Windows Small Business Server 2008 Standard w/ SP2 Ship GroupsWindows Server 2008 R2 Standard 64-bit Microprocessor, Intel Celeron, 2.26G/2M-L2 models CTO Lenovo RDX drive bay models CTO All Models Lenovo RDX 320GB cartridge models CTO All Models 90Y1170 Microprocessor, Core i5-650 / 3.20GHz models CTO 15U 15Y Lenovo RDX drive bay models CTO All Models 256MB Nvidia FX380 2xDVI models CTO All models Windows Server 2008 R2 Foundation 64-bit 16G 16J 16L 16M 16S 16U 16Y Memory modules, DDR3 ECC PC3-10600 2GB Udimm 1333 models CTO 16U 16Y Line Cord Israel models CTO 16G ThinkServerHardware Maintenance Manual Viewing and changing settings Configuring the serverUsing the Setup Utility program Starting the Setup Utility programPassword considerations Using passwordsSata Controller USB SetupEnabling or disabling a device Selecting a startup deviceRAID Level Advanced settingsExiting from the Setup Utility program Configuring RAIDDeleting RAID volumes Creating RAID volumesUpdating flashing the Uefi from a disc Using system programsUpdating system programs Updating flashing the Uefi from your operating system Recovering from a POST/UEFI update failureUsing the ThinkServer EasyStartup program Installing ThinkServer EasyManage Agent ThinkServerHardware Maintenance Manual Appendix A. Notices Electronic emissions notices Export classification noticeTelevision output notice European conformance CE mark TrademarksEuropean Union EMC Directive conformance statement Industry Canada Class B emission compliance statementThinkServerHardware Maintenance Manual Canadian Department of Communications certification label Power cord noticePower cord part number Used in these countries and regions Waste electrical and electronic equipment Weee notices Disposing of disused lithium batteries from Lenovo computers European Union EU Weee statementAppendix A. Notices ThinkServerHardware Maintenance Manual CRU IndexRemoving Page Part Number 1P P/N