Lenovo W700ds manual Message Solution

Message	Solution
The power-on	A power-on password or a supervisor password is set. Type
password prompt	the password and press Enter to use the computer. If the
	power-on password is not accepted, a supervisor password
	might have been set. Type the supervisor password and press
	Enter. If you still see the same error message, have the
	computer serviced.
The hard disk	An HDD or SSD password is set. Type the password and press
password prompt	Enter to use the computer.
	If you still see the same error message, have the computer
	serviced.
Hibernation error	The system configuration changed between the time your
	computer entered hibernation mode and the time it left this
	mode, and your computer cannot resume normal operation.
	v Restore the system configuration to what it was before your
	computer entered hibernation mode.
	v If the memory size has been changed, re-create the
	hibernation file.
Operating system	Verify the following:
not found.	v The HDD or SSD is correctly installed.
	v A startable disc is in the drive
	If you still see the same error message, check the boot
	sequence, using the BIOS Setup Utility.
EMM386 Not	Edit C:\CONFIG.SYS and change a line from
Installed - Unable to	device=C:\WINDOWS\EMM386.EXE RAM
Set Page Frame Base
Address.	to
	device=C:\WINDOWS\EMM386.EXE NOEMS
	and save this file.
CardBus	Enter the BIOS Setup Utility. Press F9 and then Enter to load
Configuration Error -	the default setting.
Device Disabled	Press F10 and then Enter to restart the system.

16ThinkPad® W700 and W700ds Service and Troubleshooting Guide