Power on/off
Power on/off
WARNING ►When the power is on, a strong light is emitted. Do not look into the lens or vents of the projector.
NOTE • Turn the power on/off in right order. Please power on the projector before the connected devices. Power off the projector after the connected devices.
STANDBY/ON
POWER TEMP LAMP
Power switch
Turning on the power
STANDBY/ON button
POWER indicator
POWER button
POWER LIGHT
OPT BLK MODE MEMORY
ASPECT IRIS
ENTER
MENU RESET
BRIGHT CONTRAST COLOR
DVI PC AUTO
COMPO
1. Make sure that the power cord is fi rmly and correctly connected to the projector and outlet.
2. Remove the lens cover, and set the power switch to the ON position.
The power indicator will light to solid orange. Then wait
several seconds because buttons may not function for these several seconds.
3. Press the button STANDBY/ON (projector) or POWER (remote control).
The projector lamp will light up and the POWER indicator will begin blinking green.
When the power is completely on, the indicator will stop blinking light green.
To display the picture, select an input signal according to the section "Selecting an input signal" (13). Then select the aspect ratio (13), adjust the picture position (7), and adjust the zoom and focus (14).
Turning off the power
1. Press the button STANDBY/ON (projector) or POWER (remote control). The message "Power off?" will appear on the
screen for approximately 5 seconds.
2. Press the button STANDBY/ON (projector) or POWER (remote control) again while the message
is visible.
The projector lamp will go off, and the POWER indicator will begin blinking orange. Then the POWER
indicator will stop blinking and light to solid orange when the lamp cooling is complete.
3. Set the power switch to the OFF position. The POWER indicator will go off.
12