Hitachi PJ-TX100 user manual Option Menu, Auto OFF, Lamp Time

Multifunctional settings

OPTION Menu				MENU [RGB]		:SELECT
				PICTURE	AUTO OFF	0
				IMAGE	LAMP TIME	0
With the OPTION menu, items shown in the table below can				INPUT	FILTER TIME	0
				SETUP	SERVICE
be performed. Perform each operation in accordance with				OPTIONSCREEN
the instructions in the table below.				EASY MENU
Item			Description
	Set the time using the ▲/▼ buttons. :
	Long (max. 99 minutes) ￿ Short (min. 0 minute = DISABLE)
		AUTO OFF	AUTO OFF
		ENABLE	DISABLE
AUTO OFF	ex.	1	0
	When the time is set to 1 to 99, the projector lamp will go off and
	the power indicator begins blinking when the passed time with a
	proper signal (without no-signal and an unsuitable signal) reaches
	at the set time. Please refer to the section “Turning Off The Power”.
	Pressing the RESET button for about 3 seconds displays the LAMP
	TIME menu.
	Select the RESET using ▲ button to reset the timer. :
	RESET ￿ CANCEL
LAMP TIME	Selecting the RESET resets the count of the lamp timer to 0.
	memo Perform this function only when you have replaced the
	lamp. The lamp timer counts the used time of the current lamp, to
	display the messages about the lamp. Incorrect performing causes
	incorrect operation of the messages.
	memo About replacing the lamp, please refer to the section” Lamp”.
	Pressing the RESET button for about 3 seconds displays the
	FILTER TIME menu.
	Select the RESET using ▲ button to reset the timer. :
	RESET ￿ CANCEL
	Selecting the RESET resets the count of the lamp timer to 0.
FILTER TIME	memo Perform this function only when you have cleaned or
	replaced the air fi lter. The fi lter timer counts the used time of the air

filter after cleaning or replacement, to display the messages about the air fi lter. Incorrect performing causes incorrect operation of the messages.

memo About caring for the air fi lter, please refer to the section “Air Filter”.

ENGLISH

29