Kyocera FS-1010 manual Check the EcoPrint setting, Confirm Toner indicator, Check the process unit

Print Quality Problems

Printed Results	Corrective Action
Faint or blurred printing	Check the EcoPrint setting.
	When this setting is On, switch it to Off on the KM-NET
	for Clients. (See the KM-NET for Clients Operation
	Guide)
	Confirm the	(toner) indicator.
	If the (toner) indicator flashes, install a new toner
	kit. (See Chapter 2)
	Clean the charger wire.
	Open the printer’s top and front covers. Remove the
	process unit from the printer and slide the charger knob
	back and forth to clean the charger wire.
	(See Chapter 2)
	Try setting the thin paper mode.
	Set the paper type to Thin in the KM-NET for Clients
	utility. (See the KM-NET for Clients Operation
	Guide)
Grey background.	Check the operator panel.
	When the	(toner) indicator flashes, install a new
	toner kit. (See Chapter 2)
	Check the process unit.
	Open the printer’s top cover and front cover, then check
	that the process unit is properly installed.

Dirt on the top edge or back of the paper	Check the transfer roller.
	Open the printer’s top and front covers. Remove the
	process unit from the printer and check whether the
	transfer roller is dirty. If so, print several pages to
	eliminate the dirt.

Check the registration roller.

Open the printer’s top and front covers. Remove the process unit from the printer and check whether the registration roller is soiled with toner. If so, wipe it clean using the supplied wiper cloth.

Characters out of position.	Check the file or program.
	Check whether the problem is being caused by a
	PRESCRIBE command error. If the problem occurs only
	with a specific file or program, the most likely cause is an
	error in a parameter to a command or command syntax.

Check the paper size setting.

Check that the paper size set in the paper source and the paper size set on the KM-NET for Clients are the same. (See the KM-NET for Clients Operation Guide)

3-4