NEC manual Disassembling the LCD Panel, NEC Versa M320 Disassembly Manual

Page 16

Disassembling the LCD Panel

Disassembling the LCD Panel

To disassemble the LCD panel, first remove the LCD module (see Removing the LCD

Module), then perform the following steps:

1. Use an appropriate tool to remove the rubbers on the LCD front cover as shown in Fig. 26

Fig. 26 Removing the rubber covers on the LCD front cover

2. Unscrew all screws shown in Fig. 27

A = M2x4.5 Silver

B = M2.5x5 Silver

Fig. 27 Screws on the LCD Module

NEC Versa M320 Disassembly Manual

Page 16

Image 16

Contents Versa M320 Disassembly Manual Table of contents NEC Versa M320 Disassembly ManualDisassembly Instructions Reassembly InstructionsOverview Technician NotesPower Supply Unit Hazardous VoltageAvoid Electrostatic Discharge AVERTISSEMENTRemoving the Battery Removing the Hard Disk DriveRemoving the Memory Module Removing the Wireless LAN & MDC Modem Module Removing the Keyboard Removing the optical disk drive Fig. 10 Removing the keyboard flat cableFig. 11 Releasing the optical drive Fig. 12 Removing the optical driveRemoving the CPU Fig. 14 Removing the heat plate4. Lift up the LED board as shown in Fig Fig. 19 Releasing the CPU Heat Sink Fig. 18 Lifting up the CPU fanM2x10 Silver Fig. 20 Removing the heat sink Fig. 21 Releasing the CPUFig. 22 Removing the Coil Removing the LCD ModuleFig. 23 Removing the LCD hinges screws Fig. 24 Releasing the plastic hinge covers Fig. 25 Lifting up the LCD moduleDisassembling the LCD Panel 4. Unscrew all screws encircled in Fig Fig. 32 Removing Wireless Antenna Removing the Top CoverFig. 31 Removing the LCD Panel hinges A = M2.5x7 Silver B = M2x4.5 Silver M2.5x7 Silver Fig. 33 Removing the top cover screwsA = M2x4.5 Silver Fig. 36 Touch Pad Assembly Removing the Touch PadFig. 35 Removing the top cover Fig. 37 Removing the FDD Removing the Floppy Disk DriveFig. 38 Lifting up the FDD Fig. 39 Audio Board screws and speakers connector Removing the Audio BoardFig. 40 Removing the audio front panel Removing the Main Board Fig. 42 Removing the RTC BatteryFig. 43 Removing the HDD flat cable connector Fig. 41 Lifting the Audio BoardFig. 44 Removing the main board screws Fig. 45 Remove the spacers on the I/O panelA = M2.5x5 Silver B = M2x4 Silver C = M2.5x5 Silver D = M5x6 SilverFig. 46 Removing Main Board Removing the speakersFig. 47 Screw at Audio Board Holder DIP Switch Setting Dip SwitchDescription SeetingScrews Versa M320 Disassembly Manual