NEC Removing the Battery, Removing the Hard Disk Drive, NEC Versa M320 Disassembly Manual

Page 5

Removing the Battery

Removing the Battery

Perform the following steps to remove the battery:

1.Make sure to power off the Versa M320.

2.Turn the unit upside down.

3.Unlock the battery and slide it out of its place as the arrow shows in Fig. 1

Fig. 1 Removing the battery

Removing the Hard Disk Drive

To remove the hard disk drive, first remove the battery (see Removing the Battery), then perform the following steps:

4. Remove the screws as shown in Fig. 2

Fig. 2 Removing the Hard disk drive cover screws

5. Lift up the hard disk drive and disconnect it as shown in Fig. 3

M2x3 Silver

NEC Versa M320 Disassembly Manual

Page 5

Image 5

Contents Versa M320 Disassembly Manual NEC Versa M320 Disassembly Manual Table of contentsReassembly Instructions Disassembly InstructionsOverview Technician NotesHazardous Voltage Power Supply UnitAvoid Electrostatic Discharge AVERTISSEMENTRemoving the Hard Disk Drive Removing the BatteryRemoving the Memory Module Removing the Wireless LAN & MDC Modem Module Removing the Keyboard Fig. 10 Removing the keyboard flat cable Removing the optical disk driveFig. 11 Releasing the optical drive Fig. 12 Removing the optical driveFig. 14 Removing the heat plate Removing the CPU4. Lift up the LED board as shown in Fig M2x10 Silver Fig. 18 Lifting up the CPU fanFig. 19 Releasing the CPU Heat Sink Fig. 21 Releasing the CPU Fig. 20 Removing the heat sinkFig. 23 Removing the LCD hinges screws Removing the LCD ModuleFig. 22 Removing the Coil Fig. 25 Lifting up the LCD module Fig. 24 Releasing the plastic hinge coversDisassembling the LCD Panel 4. Unscrew all screws encircled in Fig Fig. 31 Removing the LCD Panel hinges Removing the Top CoverFig. 32 Removing Wireless Antenna A = M2x4.5 Silver Fig. 33 Removing the top cover screwsA = M2.5x7 Silver B = M2x4.5 Silver M2.5x7 Silver Fig. 35 Removing the top cover Removing the Touch PadFig. 36 Touch Pad Assembly Fig. 38 Lifting up the FDD Removing the Floppy Disk DriveFig. 37 Removing the FDD Fig. 40 Removing the audio front panel Removing the Audio BoardFig. 39 Audio Board screws and speakers connector Fig. 42 Removing the RTC Battery Removing the Main BoardFig. 43 Removing the HDD flat cable connector Fig. 41 Lifting the Audio BoardFig. 45 Remove the spacers on the I/O panel Fig. 44 Removing the main board screwsA = M2.5x5 Silver B = M2x4 Silver C = M2.5x5 Silver D = M5x6 SilverFig. 47 Screw at Audio Board Holder Removing the speakersFig. 46 Removing Main Board Dip Switch DIP Switch SettingDescription SeetingScrews Versa M320 Disassembly Manual