Emerson 5100 installation manual Select All Programs Accessories Command Prompt

Page 28

A-2 Ethernet TCP/IP Network Connections in Windows XP & 7

Connectivity Module

6.If the computer is on the company network contact the facilities IT personnel for appropriate settings.

If it is a stand-alone computer, enter the IP # for this computer that is listed on the Interface Diagram. For example:

IP address:	169.254.1.2 (last digit must
	be different than the CM)
Subnet Mask:	255.255.0.0 (same as CM)
Gateway:	0.0.0.0 (same as CM)
Windows XP

7.Once the TCP/IP setup is complete at the computer, restart the computer (click the Start button, then click Shut Down).

8.Restart Windows, then click the Start button.

Windows XP

Select All Programs > Accessories > Command Prompt.

Windows 7

In the Command Prompt window: type cmd and press ENTER.

9.In the command prompt window type ipconfig and press ENTER. The settings are displayed.

10.In the command prompt window type ping 169.254.1.1 and press ENTER. You should see:

Reply from 169.254.1.1

This reply confirms communication between the computer and the CM. Close the command prompt window. Proceed to the appropriate section How to View & Change Configuration Pages from a Connectivity Module.

Windows 7

Image 28

Contents Connectivity Module 381333-367 CWho Should Use this Installation Manual Ii Welcome Connectivity ModulePrerequisites Important informationSpecifications Installation OverviewCheck the DIP Switch Settings for RS485 DIP Switch on bottom of unitIv Outline and Mounting Drawing Connectivity Module Wiring Diagrams Connectivity Module Connectivity Module Wiring Diagrams Vii Wiring Diagrams Connectivity Module Connectivity Module Wiring Diagrams Status LEDs LED Description LED Function / Mode of OperationConnectivity Module Status LEDs Installation How to Install the Connectivity Module on Asco 940/962 ATSsConnectivity Module Installation How to Test Communication to the Connectivity ModuleHttp//169.254.1.1/config.htm Installation Connectivity ModuleDevice Configurator Screen for 7000 & 4000 Series ATSs Group 5 Controller Configuration right sideConnectivity Module server Configuration left side Device Configurator Screen for 7000 & 4000 Series ATSsInput Name & Output Names Power Manager only Power Manager or Power Meter Configuration7000 & 4000 Series ATSs Connectivity Module Accessory 85 Descriptive Tags Assigned Detail Screen for 7000 & 4000 Series ATSs Device Configurator Screen for Series 300 ATSs Group 1 Controller Configuration right sideDevice Configurator Screen for Series 300 ATSs Connectivity Module Series 300 ATSsPower Meter Series 300 ATSs Connectity ModuleDetail Screen for Series 300 ATSs with a Power Manager Detail Screen for Series 300 ATSsPage Device Configurator Screen for Asco 940/962 ATSs Group 7A Controller Configuration right sideDevice Configurator Screen without Power Manager Device Configurator Screen with Power ManagerDetail Screen for Asco 940/962 ATSs Detail Screen for Asco 940/962 ATSs with a Power ManagerAsco 940/962 ATSs Connectivity Module Input names Display Input & Output Names screen Output names Detail Screen for Power Managers connected to a Load Detail Screen for Digital Power Meters connected to a LoadDetail Screen for Power Managers connected to a Generator Detail Screen for PowerDetail On Local Area Connection Properties screen Select All Programs Accessories Command Prompt Connectivity Module Troubleshooting A-3 Problem CauseThird Party Modbus Device Configuration Read RequestsConnectivity Module Snmp Internet-standard Protocol A-5 Snmp Trap messagesProblem Cause Solution Snmp Internet-standard Protocol Connectivity ModuleSerial No Row IP Address Subnet Mask GatewayCatalog No Address set ATS Controller PM or DPM Communication Address Form for Connectivity Module CM Communication Address Form for Connectivity Module CM Index